04'-08' Yamaha R1 fork rebuild Front Suspension Gen 4

Рет қаралды 7,959

Жыл бұрын

So as I shared during this build, I would put out a video on rebuilding front forks(seals and oil) and here it is. It was an in-betweener thus the lack of editing as you WILL notice. Hope this helps R1 people
tools - amzn.to/3UaUXwf
- amzn.to/3Nrfpa8

Пікірлер: 17

@gameboah4192 Жыл бұрын

Thank you! The quality of your instruction is great. Ill come to you for future repairs and troubleshooting

@mikel5571 6 күн бұрын

Est fork vid I’ve seen. Thank you. Gotta go do my 07 R1 now.

@daryncromie8117 Жыл бұрын

excellent teacher,easily explained thankyou!😎

@johnpittman7928 Жыл бұрын

Great video, thank you.

@connorzach81 Жыл бұрын

very helpful thank you

@clbyburn Жыл бұрын

Excelente, Gracias!!!!

@Ian.IgnitionTV 10 ай бұрын

Working on an 06 r6 right now, I haven’t found a video explaining how to get the guide bushings out and replaced, was hoping this vid would but sadly no :( and yes I j iq it’s an r1 but it’s a similar desig

@connorzach81 Жыл бұрын

could you please link the tools you used in the description?

@joelkarjalainen19 Жыл бұрын

Do you know why so many uses seal driver to put seal in place if it can be done like you did?

@donovankishbaugh460 3 ай бұрын

Great video do you know if the tools are the same for the 2012 r1

@EngineInformant 3 ай бұрын

It should be but unfortunately I cannot confirm that though

@donovankishbaugh460 3 ай бұрын

@EngineInformant ok thanks there not too expensive so I'll just get them.

@123gtt 10 ай бұрын

Also OEM is zero to 5w not 10, that too far out of spec for the small valves these forks have, the race guys sometimes use it as they have re valved to bigger, and it can pass the thicker oil easily 😊

@123gtt 10 ай бұрын

Isn’t it supposed to be filled to 101mm? Maybe the earlier models from the 07/08 rn19 have different front forks? I know some track guys go to 120mm to add a bit of air rebound. But ether way your massively over filling your forks with the wrong oil too!

@123gtt 10 ай бұрын

You did the rebound wrong, it should be all the way IN to release it. And I don’t want to be the bearer of complete bad news as I could not see very clearly but you had spring up on your seal, that’s the wrong way round, the flat part of the seal should be facing down to the floor🫣. Like I say it was hard to see

@EngineInformant 10 ай бұрын

Yes I learned this later fortunately it was a simple adjustment. thanks