On this video I show how I repaired a rusted exhaust flange using a split flange repair kit.
Пікірлер: 15
@sammyb.18488 ай бұрын
Good job brother
@edwinmartinez17568 ай бұрын
thank you brother!
@moeali1291Ай бұрын
Really good work brother question do the split flange is made specifically for crv or I can buy anyone I own 2007 crv with exact same problem bro also that gasket you used what does it called
@edwinmartinez1756Ай бұрын
Its not car specific I got mine at Autozone on the exhaust section. Thank you for your comment good luck. 💪🏻
@paulrahn80624 ай бұрын
Shouldn’t the springs be in the middle - flange and support?
@edwinmartinez17564 ай бұрын
I think the springs are there to put tension on the joint but allow it to move.
@garciahome73004 ай бұрын
Could you have used J-B Weld SteelStik - Steel Reinforced Epoxy Putty Stick instead of welding the hanger onto the repaired flange? Sez' you can use on exhaust system and can handle heat up to 300 F.
@edwinmartinez17564 ай бұрын
Maybe that's another option if you don't have a welder. have you had any luck using it?
@Cryptony19756 ай бұрын
I had a straight pipe welded in and got rid of the flange with springs. Did you repair the one near catylistic converter yet?
@edwinmartinez17566 ай бұрын
nice!.. not yet but I'm going to be under again for an o2 sensor soon.
@webdeveloper47425 ай бұрын
What join did you use as my rear join has a slight split on Honda Fr-v
@mahabubhassan19059 ай бұрын
What's the gasket size?
@edwinmartinez17569 ай бұрын
Hey buddy, I don't remember the size, but the part number was 31387 at Auto Zone. hope this helps.