5/16ths deep socket T30 torx ratchet pry bar gasket maker gasket \/ $10.60 at time of video FEL-PRO VS 50698 R Valve Cover Gasket Set www.amazon.com...
Пікірлер: 15
@Jcrosb94 Жыл бұрын
Never, EVER, put oil on the gaskets. The only time you should do that is on a filter gasket because it spins. You’re asking for a premature leak doing that to compression gaskets, especially rubbing it on like that.
@joseluiscordeirocavalcante59952 жыл бұрын
I don't understand anything in English, but I loved your video, I tried something similar here in Brazil and I didn't find it, thank you very much for posting help for the whole planet. I will subscribe and give a like. I just didn't notice if you applied some silicone glue to fix the joint
@frank8534Ай бұрын
Great video. Thanks for sharing
@zachmo889 ай бұрын
Thank you very much. Amazingly helpful video!! Saved me hundreds by avoid8ng mechanic
@blainlowe1585 ай бұрын
Helped alot. Thank you!
@user-xv8ho4ok3l4 ай бұрын
Great video!!
@gfysyoutube2 жыл бұрын
Excellent job, great angles, and footage! How's it holding up and leaks?
@randomhowto8984 Жыл бұрын
No more leaks from the valve cover. It has developed a small thermostat gasket leak though, so I will be repairing that soon.
@YeeeeeHaaaaa Жыл бұрын
I have the same vehicle year, engine and everything. I have burnt oil coming out from under the hood. Thanks for putting up this video. I thought for sure the head gasket would really be a pain but this should be a piece of cake. Thanks again.
@AmyMarie0484 Жыл бұрын
Does this video start at the beginning of the repair or will there be steps needed to get to the place where the video starts?
@randomhowto8984 Жыл бұрын
the only thing youd have to do first is remove the plastic engine cover which just pops off pretty easy.
@Arandomwoman6 ай бұрын
How does one know which gasket kit to get? Whole or half gasket kit is what I mean.
@odayalkurdi481 Жыл бұрын
Hey i got a p000a code after i replaced my valve cover gasket
@toby_parks Жыл бұрын
Did you tighten them down to 90?
@randomhowto8984 Жыл бұрын
90 inch pounds sounds about right, I just did it by feel. Not too tight since it's just a valve cover.