STM32 Blue Pill for beginners Code and diagram are at www.micropeta.com/video14
Пікірлер: 16
@lukabaks4530 Жыл бұрын
Thank you very much!
@BechirZalila2 жыл бұрын
Thank you for the good work :-)
@NizarMohideen2 жыл бұрын
Welcome!
@comandernehal85672 жыл бұрын
Very helpful...💖💖💖💖💖💖
@NizarMohideen2 жыл бұрын
Thanks 😊
@njan12429 ай бұрын
I want to make keyboard using push button that use arrow keys, space key, enter key, back space key, shift key
@marcinpozniak16054 ай бұрын
Thank youuuuu :)
@NizarMohideen4 ай бұрын
Thanks
@jnich74932 жыл бұрын
I can program the stm32f103C8 in run mode but only intermittently in debug mode (Serial wire and software reset) with errors. I'm using STM32CubeIDE v 1.7. Possibly a loose connection?
@NizarMohideen2 жыл бұрын
If you use OpenOCD debugger with software system reset, keep boot jumpers in the normal position (zero side). Thanks
@NizarMohideen2 жыл бұрын
I used OpenOCD because some of the generic STM32 will not work with GDB server. If your board has original STM32, you can try using GDB server debug probe as well. With GDB, we can use without software reset.
@GLeBaTi2 жыл бұрын
does it scheme working without resistor? If i set GPIO_PULLDOWN in pin settings?
@NizarMohideen2 жыл бұрын
Yes. We can use without a resister by using internal pull-down resistor. It is weak and for stable operation st recommends to use an external resistor. As you have said, I have used the push-button without resistor in video-no-56 in my KZfaq channel. Thanks
@SherifredSingh7 ай бұрын
hello sir.....i am getting GDM server error while the run the program can you guide me for this solution
@soriatel10 ай бұрын
doesn't work in proteus
@GktuAkbas8 ай бұрын
bro its working. just ground and b1 you need for button attach. and led wire same as the video.