Got issues with the 14L?

@@thebeardedgingerontheinter3256 do you have to remove the fan bracket to get the acc drive out? I want to inspect mine

@@thomashutcheson8487 no you just have to loosen belt and take out the bolts. But you can remove it to inspect the bull gear teeth. However if the accessory drive is moving the bull gear is also moving. So like I said in the video grab that bolt. And if it has play in it then replace it. It should not be moving left to right up down.

@@thebeardedgingerontheinter3256 I took my belt off and my pulley does not move but on my 12.7 my pulley bearings are worse slap out they just went out today but I used a crowbar to check my bull gear in the 127 and it's fine but the new 14 that I just bought I wanted to check it the same way with a crowbar but I can't take my accessory drive out unless I remove the fan bracket because one damn bolt is behind it I wish I took a picture so I could show you

@@thomashutcheson8487 just put it back on and take it to a shop it's not a big money thing to have it checked it is a big money thing if it goes out on you though