I’m sure you will feel the difference!

Thanks!

A tremendous upgrade! Thanks for watching

Thanks! Part # SHOA224550RK that’s for a 2 inch drop over factory

jewllake you don’t have to go power brakes, but the galaxie came with it! The kit can fit some 14’s but it will definitely fit like 90% of 15 inch wheels. I’m going to get some American racing wheels too!

The front is about $650 and back are around $800. If you keep an eye on sales you can get it cheaper

awesome man, hotchkis makes some really good stuff

140-13653-d is the part number for front. I had the original booster rebuilt by the Dewey booster exchange

@@OmarRamirezGalaxie excellent! Thank you.

Yes there are lots of choices. I honestly got this because of the price and the fact that they are adjustable. So you can have a smooth ride or make it firm by changing the knobs. And they are lower from stock, good bang for the buck. I would call them, they are really knowledgeable for your setup.

Just depends what you’re going to use the car for. 4 piston is fine for everyday, 6 piston has some huge rotors so they’re pretty pricey. I would call wilwood, their tech support is really good

Brushed on!

Personally I’ve always gone with wilwood, I’ve never had problems with their parts

@@OmarRamirezGalaxie I appreciate the reply. I think that’s what I’m going to do also

No, wilwood uses the original drum brake spindles

I got it from summit racing for about $650. Uses the original drum brake spindle

@@OmarRamirezGalaxie thank you.. I have 18×8 foose f-208 rims all around. Do u think the brake caliper will rub the rim?. I also want to do the rears like u did your. What's the part numbers for your fronts and rears? Thanks again

@@germanmelendez6718 mine are 15 inch and front and rear fit fine. Front are 140- 13653-D. For the rear kit you’re going to have to measure the offset on your rear hub, It also depends if you have an 8 inch or a 9 inch rear end

@@OmarRamirezGalaxie Thank you so much for the part number and your time..

@@germanmelendez6718 no problem any questions let me know.

G Rapids sure, part number 140-13653-D

@@OmarRamirezGalaxie Thank you, keep posting on this car, i need ideas for my galaxie!

Talon Sharp thanks for the comment. I did grease them a lot more after I filmed it, I felt like it needed more as well

@@OmarRamirezGalaxie it's not that you didn't have enough grease, greasing wheel bearings is forcing the grease in between the cage and the bearings on the inside. There are videos showing this technique by hand and with a bearing packer. When those bearings start turning at 20, 50 miles per hour that grease on the outside will remain on the outside and bearing failure will not be far behind.