No video
1972 C3 Corvette Project (Pt1) Header Bar and Headlight Assembly
Рет қаралды 2,758
Күн бұрынI’m assembling headlights and the bonding strip to the header bar in preparation for installing the heading bar back on to the body.
@mattmiller3673 Жыл бұрын
The boss is living his best life!
@otisgoree5711 Жыл бұрын
You're old pieces look good clean them up Prime and paint
@robjuhasz2462 Жыл бұрын
I’ve been there but I didn’t use the rivets, they’re gone. I used fusor 101ez. It’s great for fibreglass, it doesn’t set until you put heat to it.
@mayermotorsports Жыл бұрын
Yeah, I’m not sure if I were to do it again that I wouldn’t use the rivets either. I used a combination. I used panel bond on both sides of the fiberglass bonding strip. So the sheet metal is bonded to the fiberglass and the bonding strip. Is panel bonded to the actual clip.
@robjuhasz2462 Жыл бұрын
@@mayermotorsports it was very easy actually with the fusor. A header bar should be one of the first things you do.
@arlinhall2056 11 ай бұрын
I have a 79 Corvette where did you get your header bar from what's the best place thanks Arlin.
@arlinhall2056 11 ай бұрын
I have a 79 Corvette where did you get your header bar from what's the best place thanks Arlin.
@mayermotorsports 11 ай бұрын
Arlin, I bought most of my replacement parts from Corvette Central. They have probably the best selection of structural replacement parts out there. Here the url for the header bar. www.corvettecentral.com/c3-68-82/body-frame/door-floor-roof-fiberglass/68-82-front-end-reinforcement-header-bar-metal-143004?returnurl=%2fsearch%3fcurrentsearchcategoryid%3d%26q%3dheader%2bbar
Mike Landwehr Corvette Restoration
Рет қаралды 18 М.
Retro Classic Car
Рет қаралды 3 М.