Getting continuity from, first switch on door to box under seat, pretty sure its pre that something with the latch mechanism, bitch to take out, will have replacement if i go that far

The only annoyance I have is that the seat belt light light won't turn off unless the pass shoulder belt is plugged in.

Thanks for posting this video. Exactly where is the contact point to be cleaned on a 1990 Honda Accord LX two-door coupe 2.2L? My problem is the driver side seat belt is stuck in the Forward position. When I close the door it does not know that I closed the door therefore not retracting back behind the seat. With the Allen wrench tool provided by Honda I can retract the seatbelt mechanism. With the door closed, I can turn on the key and nothing happens. But when I open the door the seatbelt mechanism goes to the foward position. So the motor is working. Is there an exploded view of the door latch assembly available on the internet, so I can locate where the contact points are so I can clean them? Any help would be appreciated

Great vid - thanks! I've a different issue - the solenoid in the retract mechanism stays energized - always - even with the car off; key out. Slow drain will kill the battery over a week or so. Motor and seatbelt function and all works fine. Unplugging the four-pin retractor plug (to/from solenoid and to/from solenoid position check microswitch), and leaving the lap belt buckle wiring engaged, gets me a fast beep and seatbelt light. Anyone got ideas? I may just put a rocker switch to manually de-energize the solenoid when leaving the car. Car's pretty perfect though; '91 Accord with 318K - needs its third paint job pretty soon.

both sides stopped at same time i checked all fuses there good tested left side switches their good motor works both directions you think it's the under seat box?

of both go out same time. before you do anything. check your fuse under the hood the one that says radio back up it's a 7.5a

would this work on a 90 civic wagon?

ugghhh so annoying my shoulder belt on my cb7 wont unroll. i swapped my seats bolted everything in and its locked all rolled up smh any ideas on how to free them?

Drivers retractable seat belt will not go back. It stays forward. I can crank it back, but when I open the door it goes back to forward position. Is there a fuse that I can take out after I crank it back? So it will stay. Or can you tell me if I can replace the motor myself?

Can u just replace these with the 92-93 pillars that don’t have retractable seatbelts?

useful vid

Best to leave out the music, it detracts form the information communication.