Рет қаралды 3,602
My recently acquired 1996 Kinetic TFR vintage moped. It was not running when I had acquired it. I have replaced the following components (so far) to get it running again: New external fuel tank on the rear rack (temporary), new fuel line, new fuel petcock, new in-line fuel filter, new carburetor (the original carburetor's float bowl needle is seized and broken off inside of it, rendering the carburetor useless), cleaned the air filter box and new pedals. I've also drained and refilled the gear oil in the rear hub transmission with Amsoil synthetic gear oil. I am also using Amsoil synthetic 2-stroke oil mixed with REC 90, non-ethanol, pure gasoline inside the fuel tank. This bike fired right up afterward! This is just the first of many future phases to get this bike back to original condition. I had to get it running first before going to the next phase. The next phases will be replacing the centrifugal clutch, spark plug and wire, rear tire tube, head light lens, turn signals, LED lamps, mirrors, seat reupholstered, attempt to clean out the step-thru frame fuel tank, and whatever else I find later on. Any help and suggestions would be greatly appreciated. Please post them below in the comments section. Thank you and best regards!