1997 Toyota Tacoma 2RZ FE engine PO336 code diagnosis and fix

No video

1997 Toyota Tacoma 2RZ FE engine PO336 code diagnosis and fix

Рет қаралды 11,765

Күн бұрын

Note: this is separated out of our longer complete video on the 1997 Toyota Tacoma to aid others in diagnosis of this issue. The longer complete video includes everything we did to the vehicle and can be found in the playlist for this vehicle.
Diagnosis and fix for PO336 code (crankshaft position sensor) on a 1997 Toyota Tacoma with a 2RZ-FE engine. The issue was the distributor clocking, not any sensors or wiring. Follow along with our quick diagnosis if you have a similar issue.
For more information on us, what we do, and our projects, see our website at www.tradecraftspecialties.com.
All music courtesy of Fesliyan Studios (www.fesliyanstudios.com)
#toyota #1997 #tacoma #wrenchwranglers #autorepair #repair

Пікірлер: 12

@wyldeman 10 ай бұрын

Thank You! I have a 3RZ Replaced the timing chain and did s balance shafts delete but kept getting the P0336. Tore all down just to make sure I didn't do anything wrong. I didn't.... so this went on for 3 days. I put the code in KZfaq and up pooped your vid..... I advanced the distributor 1 tooth and BAMMMMMM .... idles good and code gone....Thank You again!

@levibingham3048 Жыл бұрын

Thx for sharing. People like you help people like me more than you know! Keep it up my elite brethren!

@wildfire8341 Жыл бұрын

Nice work .. interesting find :) 😀

@MorganEades-rn6sz 2 ай бұрын

Did the pickup for the camshaft sensor line up completely even after you adjusted timing ?

@wrenchwranglers 2 ай бұрын

It did not line up exactly because there is some mechanical advance built in, but it was closer. I wish I had thought to measure it, but unfortunately I did not.

@MorganEades-rn6sz 2 ай бұрын

Thanks I’m getting a p0336 code and I’ve replaced all the sensors, distributor, and computer and still having the same issue so I’m gonna go out on a limb and assume it’s a wiring issue somewhere

@wrenchwranglers 2 ай бұрын

@@MorganEades-rn6sz ugh that’s what we all dread…. The wire-by-wire drudgery.

@MorganEades-rn6sz 2 ай бұрын

Yes no kidding, I’ve messed with some of the wires coming off the distributor where it runs into the main harness and now the code is gone but truck is still doing the same thing

@CarlosLopez-qe8zl 2 ай бұрын

Please, could you tell me how connected your scaner tool?

@wrenchwranglers 2 ай бұрын

In this case it’s just a normal OBDII scanner that plugs into the factory OBDII port below the steering wheel.

@Aztlan619 11 ай бұрын

How would you go about doing this if you’re not at tdc I replaced my distributor (same engine but ‘95) but I’m guessing I’m about a tooth off as well because I’m misfiring at 3k rpm and high idle (manual tran). Got same code too p0336

@wrenchwranglers 11 ай бұрын

Rotating the distributor? You can can rotate it at any point, not just TDC. You just have to watch the distributor rotor and note where it is before and after to see how much you have changed it.