2.7 Tiburon Timing Belt Water pump

Рет қаралды 27,746

teebrron

6 жыл бұрын

like an acrobat or magician the timing belt runs right thru the engine mount. #timing #belt #water #pump

Пікірлер: 23

@rklockhart 5 жыл бұрын

Dude, this is by far the best non tutorial video i've seen.... Thanks for including the irritating aspects of this repair, theyre totally valid.. i don't think they could have found a worse spot to put a water pump.........

@MJT-DA 4 жыл бұрын

Oh trust me ford did for their v8 mustang's lol

@ace5357 3 жыл бұрын

I see that you reference a repair guide through out your video. Where did you get it? I've been trying to find one for my 03 model

@teebrron 3 жыл бұрын

Hi Arturo, thanks for the comment, Please visit my webpage at clic.ly/teebrron Click the drop down menu, there's a link there for the manual, Hope i was able to help, please let me know if it works, thanks.

@mijgreco3914 2 жыл бұрын

Haha so where does the timing belt run right around again, missed that bit. But seriously surely they pulling the piss making so much work to change one belt.

@dustintunis9347 4 жыл бұрын

Try to break loose the power steering bolt before removing the drive belt. You probably won't need the pry bar.

@AlphaBobFloridaOverlord 6 жыл бұрын

Extremely helpful - valuable, concise information. Going to do my 2008 Tiburon SE today, or tomorrow (after I finish the clutch). Thanks!

@ArthurTipaldi 5 жыл бұрын

Did you maje it? :D

@shantahsieh2877 6 жыл бұрын

You can find something like this on the Avasva page. Full step-by-step instructions right on your desk.

@twadam5218 4 жыл бұрын

Good job

@nicholasadkins3340 2 ай бұрын

I can’t remove my crank shaft pulley how much torque does your driver got?

@teebrron 2 ай бұрын

I used a mastercraft electric impact driver Specs 120volt 7.5amp 900watt and 2200rpm. Its normal for the bolt to seize and the crankshaft pulley to be stuck on. It took me 2 days to remove the one single bolt and pulley. If your working on a V6 Tiburon its probably about 16 to 21 years old now so the bolt will be seized up, Heat, torch, leverage with breaker bar or impact, penetrating oil, If that all fails start the car for a sec and let the motor break the nut loose.

@nicholasadkins3340 2 ай бұрын

@@teebrron Yes I’m working on a v6 Tiburon I been stuck for weeks on how to remove but this comment is a Game changer thanks so much man

@crazyamericangamer7036 5 жыл бұрын

How many miles was this done at?

@bruhh8908 3 жыл бұрын

haha Thanks

@gashan72 Жыл бұрын

What was the pi. At end

@Solarlifeoffgrid 3 жыл бұрын

What ?? Oil so you gotta remove the oil pan??? For what

@exiled_tuscani7660 3 жыл бұрын

No since he’s doing it from the engine bay you have to remove the engine mount since the timing belt runs through it so you support the engine from the oil pan with a jack stand or something to keep it from rocking