Thanks so much, I struggled with this for 2 hours, the only thing I can recommend is make sure you have the old keys close to the Tumblr, I didn’t have it close enough, and it would not go into reprogram mode.

Thank you for the video and I am still trying to get my jeep programmed.

Also, when you do the method from the video author, you need to keep the original keys or you will have to buy new locking cylinders for your front doors and hatch which would be expensive

I took the skim module out from under the column. Had the new keys cut as the original key. Cable tied the old key in the transponder loop of the skim module. Jeep starts with both new keys. If something goes wrong. The old key is there for emergency.

Thanks for the tip! Got a link for those blank keys?

Lowes refuses to cut my existing jeep key with the two blanks. they said I had to use their chipped blank for like $75 but their machine won't read my existing chipped factory keys.

Hi Man, can I have a question? I don't have a new ignition tumbler, but one of my old key is damaged. The chip inside works fine, its just the physical key itself its too damaged and i can't turn the key. Now my question: Can I buy those blank keys from amazon, and program them with the same technique as you used in the video? But instead of "new black key" as you used in video, i would insert blank key from amazon directly? So my steps would be: 1. insert blank key from amazon 2. encolse first original key 3. turn to start 4. shut it off 5. enclose second original key 6. turn on 7. wait for key light flashing 8. shut it off 9. inser the blank from amazon again and start? Will this work?

What if you only have 1 original key will it work

What if old keys were stolen