any sienna 2004 and after driver side cv axle and axle seal
Пікірлер: 101
@cu2tonite3 ай бұрын
Thanks for the thorough video. By far the best video on removing the axle on these Toyotas. My RX350 I discovered has grease all over inside my rim. Got the kit today from the Lexus dealer $70.00 out the door.
@JM-AUTO3 ай бұрын
THANKS FOR SHARING
@victorvillagomez441311 ай бұрын
Man this is a very detailed video, thanks for doing this!
@JM-AUTO11 ай бұрын
Glad you enjoyed it! thanks for sharing.
@timowens7214 Жыл бұрын
Thank you for taking your time and showing how to properly do it.
@JM-AUTO Жыл бұрын
My pleasure! and thanks for visiting this channel I appreciate it.
@internallyinteral Жыл бұрын
Wow full process AND showing part numbers. Nice job!
@JM-AUTO Жыл бұрын
thank you I appreciate it.
@rc30748 ай бұрын
Excellent instructions, thank you. The seal in your video leaked on my 2011 XLE AWD and I had to change it. I used NOS 20067 from NAPA and it worked perfectly for the driver side. Thanks again.
@JM-AUTO8 ай бұрын
im glad you did a great job and thanks for sharing I appreciate it very much
@leepatterson443511 ай бұрын
thanks for talking me through this...I will be replacing the axles and seals on a 2006, both sides.
@JM-AUTO11 ай бұрын
Glad I could help and thanks for sharing.
@luisontiveros5692Ай бұрын
Did you buy this same seal for your 2006 ? I have a 2004 sienna you think it will work or it’s different ? I think it’s different
@youtubeuserl72379 ай бұрын
Thank you sir, you helped me a lot. I had problems taking out the axle, but I used a cv joint puller and a slice hammer and it came out easily
@JM-AUTO9 ай бұрын
Glad it helped and thanks for the time on the channel.
@swagmamma_152 ай бұрын
Great video! Appreciate your step by step and replacement part info.
@JM-AUTO2 ай бұрын
Glad it was helpful! and thanks for sharing
@matthewdo90277 ай бұрын
Thanks for sharing, amigo. The passenger side is harder because the axle is longer with more sections.
@JM-AUTO7 ай бұрын
thanks for sharing, yes a little bit harder, i also have a video on how to remove it n installing it on the passenger side on this same sienna.
@user-il1vn3cn9n26 күн бұрын
Thank you so much. You are very good at your craft.
@JM-AUTO25 күн бұрын
You are welcome 😊
@LGTheOneFreeMan3 ай бұрын
Hey, on Toyotas, if the axle isn't banging or bonking around, and seems to still be okay despite the boot being torn, most of the time the mechanics just re-boot and re-grease them. Sometimes putting an aftermarket CV can open an entire other can of worms the owner wasn't expecting. There's a reason Toyota axles cost a few hundred dollars apiece.
@PracticalC5 ай бұрын
Great vid. Thanks for your time. You are a good mechanic!
@JM-AUTO5 ай бұрын
Thanks 👍, very much appreciate it.
@CraquedEggs Жыл бұрын
Good educational video. Thanks for taking to the time to share your knowledge.
@JM-AUTO Жыл бұрын
thank you I appreciate it.
@teachthestory Жыл бұрын
Thank you for showing the entire process. Great job! \
@JM-AUTO Жыл бұрын
im glad, thank you.
@JM-AUTO Жыл бұрын
thank you appreciate it very much.
@GA-250RX2 ай бұрын
Great job with the explanations! I really appreciate the vid!
@JM-AUTO2 ай бұрын
Glad you enjoyed it! thanks
@UR.CRISTIANO.FANPAGE07Ай бұрын
Great detailed video!!!! Thank you
@JM-AUTOАй бұрын
thank you
@SteveOfTheMountains8 ай бұрын
Thank you. I will watch this a bunch before I do it
@JM-AUTO8 ай бұрын
im glad this video was helpful and thanks for watching, let me know how every thing went.
@jonathancrews1695 ай бұрын
This was very helpful sir, much appreciated.
@JM-AUTO5 ай бұрын
Glad it helped and thanks for sharing.
@waldobenitez5 ай бұрын
my friend good video but you put the 2 bolts that hold the Knuckle to the strut from back to front and the correct way to put them is from front to back
@JM-AUTO5 ай бұрын
fortunately they can go either ways, appreciate you sharing.
@vitaliyburyakov1786 Жыл бұрын
good job on the replacement, very informative. Thanks
@JM-AUTO Жыл бұрын
You're welcome! and thanks for watching.
@jonaspetelo71463 ай бұрын
Thank you great video!
@JM-AUTO3 ай бұрын
thank you
@PrincessAshleighStar Жыл бұрын
Thank you so very much for this video ❤
@JM-AUTO Жыл бұрын
you welcome and thanks for visiting this chamme.
@denisaparicio7313 Жыл бұрын
Great instructive video man !
@JM-AUTO Жыл бұрын
thank you I appreciate it very much.
@sandiegoman6611 ай бұрын
very clear and consise. thank you
@JM-AUTO11 ай бұрын
Glad you liked it, thank you.
@kellyshanley45447 ай бұрын
Great video!! Thank you!!
@JM-AUTO7 ай бұрын
thank you appreciate it.
@jeremyh.12529 ай бұрын
Thank you for sharing the part number on the seal. What did you put on the seal before putting it in? Grease or ATF to lube it???
@JM-AUTO9 ай бұрын
hi, thanks for watching, ATF on the seal so it goes inside smoothly.
@jeremyh.12529 ай бұрын
Thanks again. Managed to do the cv axle on Sunday. Your video was a big help. It wasn’t too difficult but, you definitely make it look much easier lol.
@JM-AUTO9 ай бұрын
@@jeremyh.1252 im glad you did a great job n thanks for taking the time to support my channel.
@xiaofeng7568 Жыл бұрын
You are unbelievable !help me to understand ❤
@JM-AUTO Жыл бұрын
Happy to hear that! thank you I appreciate it very much.
@derek1195 Жыл бұрын
Pretty dang good video thanks
@JM-AUTO Жыл бұрын
thank you very much.
@tn5898Ай бұрын
Hi, I have a 2006 Toyota van , I felt the steering wheel is shaking a bit when accelerating above 50 miles , and outer edge of both tires are worn out badly , so could this is a sign of fail cv axels or something else ? Thanks in advance
@JM-AUTOАй бұрын
Thanks for sharing, number of bad components cause this issue, most of the time bad after market cv axles(only cv axles from toyota will fix it, very expensive) also unbalance tires, ujoints in the steering colunm, bad rims, bad steering rack, inner or outer tie rods, wrong size tires.
@prtbone783 ай бұрын
Bought me cardone they said for my yr and drivetrain went to put in today they dont mach up mind you i purchased them 3 yrs ago didnt need them but now i do rock auto has same with same part number how if they dont match driver sode is about 4 inches to short i somewhat measured passenger side got an estimate of 50 inches long cardone one is like 40 or a little over.. i cannot put them on itll be a disaster
@JM-AUTO3 ай бұрын
may be you got the wrong ones or difective ones, hope you get the right ones thanks for sharing.
@prtbone783 ай бұрын
@JMAutoRepairnum1 idk how says it's right I got them 3 yrs ago now stuck with them unless I call them and try and see if can take back but doubt it and how wrong if rock auto says it's same part number as the ones I have im so upset and confused what to do now I put it back in since it's wrong I have a squealing noise when drive it stops when I brake .... any idea ? Thanks for the reply appreciate you and the video
@mikimiki195 Жыл бұрын
Great video I’m working on my daughters 09 Lexus is250 AWD her differential went out do you know what are torque specs on that differential There are four bolts on drive shaft, two 19mm bolts on bottom of the differential And three hex bolts on neck of the differential? 2nd question should I apply some grease on differential seals where cv axles goes Thanks
@JM-AUTO Жыл бұрын
propeller shaft assembly x front flange 58 ft- lbf. propeller shaft assembly x rear diffrential companion flange 58 ft-lbf. center support bearing assembly no.1 x boby36 ft-lbf. you should lubricate the seals with oil. and thanks for visiting my channel. I really appreciate it.
@mikimiki195 Жыл бұрын
@@JM-AUTO so drive shaft 58lb
@JM-AUTO Жыл бұрын
@@mikimiki195 The Propeller shaft connects to the Universal joint flange by 4 bolts, These bolts are tightened to 58 ft lbs. thanks for visiting my channel.
@mikimiki195 Жыл бұрын
@@JM-AUTO thanks
@usdpaulp Жыл бұрын
I watched a video that said you have to do an alignment after replacing the front struts on a 2004 sienna awd. Is that true?
@JM-AUTO Жыл бұрын
most of the time you have to do aligment after replacing suspension parts, but if the vehicule pulls straight ahead and not to any side when driving then there is no need for aligment, also to do aligment other parts of the suspension need to be in good condition. thanks for visiting my channel I really appreciate it.
@javierortiz383425 күн бұрын
How much should I charge for a job like this? I have done bit have no idea of prices!!
@JM-AUTO24 күн бұрын
about $100 or $150
@metuiselabolekinaivalu7787 Жыл бұрын
Thank you
@JM-AUTO Жыл бұрын
You're welcome and thanks for visiting my channel.
@chocotoynk2931 Жыл бұрын
do i need wheel alignment after doing this? and is it ok to only change 1 side of axle or both sides are needed to be replaced?
@JM-AUTO Жыл бұрын
in this case you only do the affected side, for some other components it is nesessary to replace both sides but not on cv axles. you dont really need an aligment epecially if you dont remove tie rods but if you remove other suspension componentes then it would be good idea to check if you need wheel aligment.
@maniac321456 ай бұрын
Do you need to add transmission oil, since the seal was leaking?
@JM-AUTO6 ай бұрын
yes you should add it if it leaks and check it it even if it doesn't leak, in this case I had just done the tranny fluid change on this sienna only like a month ago.
@thadonofdetroit7679 Жыл бұрын
Where did you get the seal from, I have a 2006 sienna xle front wheel drive, and I need the CV axle seal, and can't find one anywhere
@JM-AUTO Жыл бұрын
autozone should have it, I got it from an auto part called tinker, but autozone has it too. thanks for visiting my channel i appreciate it.
@evelynrodriguez8652 Жыл бұрын
Is that axle lifetime warranty?I am looking for an affordable but good axle for a 2011 Sienna
@JM-AUTO Жыл бұрын
hi Evelyn, no this axle has no lifetime warranty, only one year and thanks for visiting my channel I really apreciate it.
@noahsmall2570 Жыл бұрын
Which way does it go back in?
@thadonofdetroit7679 Жыл бұрын
And would that seal by part number fit my vehicle?
@JM-AUTO Жыл бұрын
no it wont fit yours, it is different. sorry.
@mityashin Жыл бұрын
Do I have to buy sealed separately?
@JM-AUTO Жыл бұрын
if you change the axle seal yes.
@mityashin Жыл бұрын
@@JM-AUTO so I don’t have to change it if it’s good
@gabewalker7604 Жыл бұрын
Did you have a leak on the axle shaft seal?
@JM-AUTO Жыл бұрын
yes very little that is why I replaced it and thanks for the visit.
@gabewalker7604 Жыл бұрын
I’m meaning did you have a leak after you swapped it with the new seal?
@gabewalker7604 Жыл бұрын
Did the new seal leak? I was always taught that’s you’re suppose to tap the new seal all the way in….
@JM-AUTO Жыл бұрын
@@gabewalker7604 no it did not leak at all after replacing it. all was good, yes always look how the old one is so you can installe it the same way but it has at limit up to where it is supposed to stay.
@gabewalker7604 Жыл бұрын
In the video it looks like you put it flush with the edge of the case of the transmission is that what you did or did you push it all the way in because I am right here doing it right now lol
@mityashin Жыл бұрын
The seal doesn’t fit 2017 sienna
@jeffro4kag2068 ай бұрын
Thats easy, try the passenger side!
@JM-AUTO8 ай бұрын
yes this is the link here passenger side for the same sienna kzfaq.info/get/bejne/r7yYd7Spvbq8lIk.html but it is schedule for this saturday coming up, thanks for for the visit.