2005 - 2010 Hummer H3 Backup Camera Install

Рет қаралды 17,895

Күн бұрын

Parts used listed in the description below!
Watch a full tutorial as a 2007 Hummer H3 will have a new aftermarket backup camera installed. This camera will be paired with an aftermarket radio that was installed previously. We will be mounting this camera to the spare tire studs in the rear of the vehicle.
This video applies to Hummer H3 models for years 2006, 2007, 2008, 2009, and 2010. This video demonstrates backup camera wiring, installation, and testing.
Click, here to see the radio install on this Hummer H3:
• 2005 - 2010 Hummer H3 ...
Click here to see the headlight and fog light upgrade on this H3:
• Hummer H3 Headlight / ...
Click here to see a general backup camera tutorial video:
• Car Backup Cameras Exp...
If you have any questions, leave a comment below! Be sure to like and subscribe!
Backup Camera Kit (Amazon Associate Paid Link):
*Red Wolf JKU Camera Kit: amzn.to/3Gh8eNs
Radio Parts shown in this install (Amazon Associate Paid Links):
*Sony XAV-AX100: amzn.to/3e1qGgJ
*Metra 95-3304 Dash Kit: amzn.to/3i2Neil
*Crux SOCGM-17C Wiring Harness Adapter: amzn.to/3h5gG7N
--If you have steering wheel volume controls as well, use the Crux SOOGM-15 Harness Adapter instead: amzn.to/3EfogWt
*Metra 40-GM10 Antenna Adapter: amzn.to/3vZwXjQ
*USB Flush mount Adapter: amzn.to/3gGHkms
Disclosure: As an Amazon Associate I earn from qualifying purchases

Пікірлер: 13

@ProvoBeastAudio 2 жыл бұрын

Parts used linked in the description of the video!

@TOMRYANLUKE 7 ай бұрын

Thank you so much, this product worked great on my hummer.

@markii72 2 жыл бұрын

That ventilation opening in the back door, does it have a flap on it so it's shut closed normally? If it does and you routed a cable through it, the interior of that car will be very humid in humid weather. I routed a backup camera like this once, then re-routed it through a grommet later because of the sudden "rainforest smell" in the parked car (was not a H3 though).

@fayereyes1300 5 ай бұрын

How and where do you add the extra red accessory wire?

@Jmpmaster83 Жыл бұрын

You said bc of covid you couldn’t get the h3 version, can you provide the link to the h3 one so I can see if I can buy it now? Everything I’ve found is nothing but jeep brackets

@chrisfoster467 Жыл бұрын

I just ordered everything in the description, with the exception of the AX100. I got a AX3200 because I couldn't find the AX100. Used your videos as a step by step for radio and camera. Everything works except the reverse trigger. The camera button on the home screen works but not when the gear selector is put in R. I rang out the harness and it appears correct (soldered connections). Any advice is appreciated...

@ProvoBeastAudio Жыл бұрын

Sounds like an issue with the reverse trigger wire on the smart harness (I assume Crux). I suggest reaching out to crux customer support for help. Worst case scenario, you just run a wire from the reverse light + to the reverse trigger input.

@chrisfoster467 Жыл бұрын

@@ProvoBeastAudio Yes the Crux SOCGM-17C. I think unfortunately you are correct, the harness tested ok but I assume the module is faulty. I am going to order a new one and try swapping just the module. For now the wife is just using the home screen camera button and is happy. I will report back...Thank you, great videos.

@chrisfoster467 Жыл бұрын

Figured I would update my comments. I contacted Crux and was told the 2008 H3 does not have the ability to trigger the backup camera from the smart harness. I would need to tap the reverse light 12v +. Which I did at the drivers kick panel. Crux customer service is top notch but definitely disappointed in the extra unexpected work. Also, my rear door speakers alternate cutting in and out unless the connector into the Crux module has pressure on it from the side. That took a bit to figure out as I tested the harness again for continuity, this time while manipulating, thinking I had a bad wire or terminal.