In today's video - I repair the ‪@MaxJax‬ lift finally - and I get the Corvette in the air. I had some wiring next to the starter melt - and then land in the belly pan and try to catch the pig mat on fire.
After getting the car in the air, and the belly pan off - I look at the damange from the melted wire and get started on the repairs.
After removing the ‪@Kookstv‬ 2" header - get enough room to fix up the wire loom, add some fire sleeve protection - and re-route the battery cables going to the starter.
Tools/Parts Used:
Lazzars MaxJax Seals: 119102
Punch Set: amzn.to/492Twr3
Hydraulic Lift Fluid: amzn.to/4e8m0mw
Tesa Tape: amzn.to/3Rd8pRg
1.5" Heat Shrink Tubing: amzn.to/3RajO41
Battery Cable: amzn.to/4bEHndy
Battery Cable Lugs: amzn.to/3VpLDrI
Hydraulic Crimper: amzn.to/3yV8keo
Fire Sleeve: RaceFlux/Improved Racing
3/4" Heat Sleeve: amzn.to/3ySaMCq
1/2" Heave Sleeve: amzn.to/3VpWemB
Milwaukee M18 Battery: amzn.to/3il6loT
Milwaukee Charger:amzn.to/2YcteUx
Craftsman Hex Socket Set: amzn.to/3vvhJVU
Craftsman Extended 1/2 ratchet: amzn.to/3opxr1q
Craftsman Ratcheting 12MM Wrench: amzn.to/3EuTMQE
Craftsman Socket Set: amzn.to/3z315NP
Milwaukee Charger: amzn.to/3keJTP7
Milwaukee 3/8 Ratchet: amzn.to/3wt7G2O
Thanks everyone for all of your support!
Help support the channel by checking out the store:
www.bonecrrushe...
Send me stuff!
Craig BonecrrusherSS
PO BOX 63
Denver, NC 28037
The Tools I Use: www.amazon.com...
Follow me on Instagram: / bonecrrusherss
Follow me on Twitter: / bonecrrusherss
Like me on Facebook: / bonecrrusherss
This post/video contains affiliate links. As an Amazon Associate, I may receive commission from qualifying purchases made through my links.