I stacked 2 x 6’s on a floor jack and then jacked it up
@undefinedrawdawg33412 жыл бұрын
Great vid, thank you!!
@christopherlemieux7957 Жыл бұрын
Did you need to loosen the mount bolts in the front of the truck too?
@ScottPeairson Жыл бұрын
No I did not, and a good tip is to loosen all of the cab bolts but only replace one side at a time so the cab doesn’t try to slide off the frame. Unless you have a two post lift that you can lift the whole cab at the same time.
@joeroe2839 Жыл бұрын
Did u have to even loosen the front ones by the engine ?? I just want to do my cab ones not the front ones by the engine ..pmz lmk thanks
@ScottPeairson Жыл бұрын
No Sir I didn’t have to loosen the front up and another tip only do one side at a time so your cab doesn’t slide off. You only need to raise the cab a couple of inches.
@joeroe2839 Жыл бұрын
@@ScottPeairson awesome thanx for the tip god 🙌 bless
@matthewkochan4808 Жыл бұрын
Great video ! Did you have to loosen up the steering shaft before you raised the cab ?
@ScottPeairson Жыл бұрын
No sir I didn’t but I didn’t raise the cab up much.
@odaglas01 Жыл бұрын
Where did you buy the replacement bushing what brand? Thanks. Sorry just saw where but you replaced all 8? Or just 6?
@ScottPeairson Жыл бұрын
I just replaced the 4 foam bushings. The rubber bushings were still good. I got them from my local Ford dealer.
@paddlinh2o3692 жыл бұрын
How did you raise the cab?
@brandonhenderson3186 Жыл бұрын
You referenced raising the cab multiple times, but never showed how you did it. To be honest it looked like you didn't raise the cab from what I could see.
@ScottPeairson Жыл бұрын
I did have to lift up a few inches but I didn’t want any liability on how I lifted it.
@brandonhenderson7641 Жыл бұрын
@@ScottPeairson Understood. I can probably figure it out. Thank you for the video.