Thanks. Tools needed, two sockets, a 10mm and 12mm, a socket extension, replacement clips, pliers, a flat tip screw driver AND four flat thin wedges to open the clips holding the fan assembly/condenser to radiator. That was great to know. Excellent video.

awesome video mate, thank you for sharing with us, had to change a radiator out for a friend and honestly without this it have taken me a day instead of a couple of hours. perfect 10/10 👍

Thank you brother, I’m just waiting for the radiator part to be delivered 2 days from now. Have a blessed day. Great video.

just did this myself, had a look at your video first to make sure this would be easy for an I.T guy and it was EASY, Thanks great video. I found you don't have to take off the fan housing, it's easier if you pop the clips for the compressor and slightly pull compressor rad up so it clears the clips slightly then do the other side, jam a screw drive in the top clips, reach down and push the bottom clips with your thumbs like you would grip a hammer or baseball bat. once you've done both sides you can pull the rad and fan housing out entirely, then separate them outside the car.

Thank you so much for this video. Made it possible to replace my radiator (2011 lancer).

Well done mate. I replaced my 2011 outlander’s radiator, all the process is straightforward except the removing the fan/condenser from the old radiator, as the four clips are bit tricky to release the fan/condenser. I had to cut the clips to release the fan/condenser, when I install the fan/condenser, it is also tricky to put them back.

This help ALOT !!! Thank you

Thank you for the details, very clear and straight forward. much appreciated. question though, if changing the radiator, isn't better ( or easier) to not worry about the painfull clips and just break them? they are part of the rad. and i'm assuming the new one will have new clips. also, can the fan assembly come out with the radiator then worry about it once the rad is out?

Can you remove the fan assembly together with the radiator ?

Good video very helpful

Good video well done

EXCELENTE.

you didnt say why you changed the radiator where was the issue etc etc, any common leaks or faults with them?

Good video.

What the first 2 things you remove in the called? I hit a deer and I need the 2 things cause my hood won't close and It need to be fixed

Can I use for 2011 lancer?

Bro you should dismantle the sport light first and it will be easy for you access the lower radiator hose.

I am curious as to why when you had the radiator and the fan both unsecured why did you not just remove it in one said piece and then remove the fan after you've taken it off or out of the vehicle and then replacing the fan on the new radiator and place it back in place just a question

Can i do this on a 2015 lancer se

Will the same apply to a 2009?

I need to replace my engine fan motor, any video on that?

Hi Sir, What type and size of bolts that use in front radiator support?

is there any bolt holding the radiator or nothing its okay that the radiator have some movements on the left side? because mine has a movements

Can I use this method on my 2008 Mitsubishi lancer?

Wondering why he didn't have to take off his hood latch,,I did..and disconnect the cable...🤔 2008 btw

is this car cvt?

What model / type of the radiator?

Where the installation video ?