Need a better way to wire them up so you don't have to hook to obd2 port.
@TakkaFlakkaFlame5 жыл бұрын
what torque to spec, just tighten the shit out of it
@akbychoice7 жыл бұрын
Deforming the cable with visegrips? Not good if that happens
@nick7.3987 ай бұрын
What’s the correct way to do it
@changofeo97958 ай бұрын
One of the wedges bolt broke and came off where does it go?
@alejandronunez82327 жыл бұрын
What if you have a tuner connected to the ob2
@jasonman15157 жыл бұрын
ya i was thinking about that too. thought just tap it in to the dome lights or door lights.
@dalegraven7697Ай бұрын
Nah get a splitter
@cgrobe212 жыл бұрын
Is there any other availability to install this without using the odb2 port? That's the only thing I don't like
@justingolden2 жыл бұрын
you'd have to wire it in just like you would with older superduties, power ground door switch ect. amp does make an ob2 splitter as well so you have access to 2 ports. it worked for my friend for the boards and a tuner. cheap ones of amazon ect don't work though.
@cgrobe212 жыл бұрын
@Justin Francis oh alright. Yeah in my thoughts I'd rather it hard wired for a cleaner look as if it was factory. That's why I asked. I been wanted a set of these for ever. Running boards just take up so much clearance underneath but I can't not have running boards. Saves your seats from getting torn up and easy to get in the truck.
@cgrobe212 жыл бұрын
@Justin Francis I try and stay away from Amazon and ebay stuff. It's never what you think or hoping you're getting.
@rossbagley90154 жыл бұрын
Guys, seriously: stop using impact wrenches to tighten nuts and bolts. Removing bolts and nuts with impact wrench: great idea, saves time. Tightening nuts and bolts with an impact wrench: awful idea, you're over-torquing everything.
@miguellavoie43733 жыл бұрын
This is too funny. You obviously dont spend a whole lot of time in a shop to know just how much time and profanity power tools save you.
@cgrobe212 жыл бұрын
I've been doing it for years. I never strip any bolts. If you know how to use a tool you wont.. simple as that
@customyamaha4 жыл бұрын
nice job stripping the bolt lol
@ryanwalsh530510 ай бұрын
Be better to drill a small hole, add a grommet and run the light wires through the metal and not so tightly below it. Thats a chafing nightmare.
@nabielsuleiman70393 жыл бұрын
Wondering what the part number is that to use then where are you got them from everyone is out of stock on these only place I found maybe Amazon might get them for me or have them available some info would be nice thank you
@stage3motorsports3 жыл бұрын
Hi Nabiel, give us a call for more help on these steps 623-434-5277