2008 Hyundai Elantra Door Lock Actuator Replacement

No video

2008 Hyundai Elantra Door Lock Actuator Replacement - Passenger Door Won't Lock Fix

Рет қаралды 3,482

Күн бұрын

Get Free Shipping and save 25% on Amsoil: www.amsoil.com...
Find AMSOIL products for your vehicle: insaneoil.com/
Learn how to start your own AMSOIL dealership: joinamsoil.com...
Products used in this video include:
A-Premium Door Lock Actuator
www.amazon.com...

Пікірлер: 15

@BenHoffman-fb7qc 3 ай бұрын

thanks! exactly what I was working on and I got close but you showed me what I was missing

@InsaneOil 3 ай бұрын

Thanks for the comment. Much appreciated.

@rss608 7 ай бұрын

very good video, very detailed. I like the part where you take the time to cut the tape that holds on the wire harness to the metal door panel... very detail oriented.... any diff for the drivers side with key lock?

@rss608 7 ай бұрын

got me to subscribe!

@InsaneOil 7 ай бұрын

Thanks for the comment. Much appreciated. The drivers side should be nearly the same.

@ashdagger8006 2 ай бұрын

can you please show how to remove the rear bumper and put it back on please?

@user-ow7ib5lj5n 6 ай бұрын

Hi, do you have video of stabilizer bushing replacement. Thank you

@aviles113 27 күн бұрын

I’m having troubles with my glass tilting and basically get stuck causing window to get not roll up past 3/4. Seems like the left side guide rail gets “stuck” or loose but not 100% sure, any tips or suggestions?

@InsaneOil 26 күн бұрын

I haven’t had that same issue on this car but I have had a similar issue on my other vehicle… kzfaq.info/get/bejne/eK9mpcuYqdm0YoE.htmlsi=uygMoHf2xhwL8KpM

@drunkmexican814 6 ай бұрын

I was able to go through the whole process myself, thank you A LOT. Something I would've added are the rubber pieces that the window glass sits on. Just to make sure they are on properly as well as the metal brackets the screws screw into are sitting properly as well.

@InsaneOil 6 ай бұрын

Thanks for the comment and the tips.

@rss608 4 ай бұрын

I had to check those, one came off and fell in the bottom. So, used mask tape to hold in place while dropping the window but realized that I could have just used the bolts and left them loose. I had to do the drivers side. only strange bit was the white nylon fittings didn't fit my after market lock mech. Had to file down one corner on the nylon fitting 1/8". I had to file it to get it to seat correctly. all seems to be working correctly.

@InsaneOil 4 ай бұрын

@@rss608 Sounds like a successful repair.

@aviles113 27 күн бұрын