Рет қаралды 114,746
How to change brake pad for 2013 Toyota Corolla; applies to multiple car years!
Tool List:
1. socket wrench
2. 14mm socket
3. rubber mallet or hammer(possibly)
4. jack stands/jack
5. 4" C-clamp or brake caliper tool (can get loaner from auto-parts store)
Torque Specs:
Caliper Pin Bolts: Approximately 20 -25 ft-lb (snug tight)
Music:
I Don't See the Branches, I See the Leaves by Chris Zabriskie is licensed under a Creative Commons Attribution license (creativecommon...)
Source: chriszabriskie....
Artist: chriszabriskie....
*If the video was helpful, remember to give it a "thumbs up" and consider subscribing. New videos every month*
Disclaimer:
Due to factors beyond the control of Engineered Mojo, I cannot guarantee against improper use or unauthorized modifications of this information. Engineered Mojo assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. Engineered Mojo recommends safe practices when working on vehicles and or with tools seen or implied in this video. Due to factors beyond the control of Engineered Mojo, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not Engineered Mojo.