2009 Ford Ranger - Coil Spring Replacement - Episode 1 - Part 3 of 1
Рет қаралды 1,209
Жыл бұрынThis video chronicles the short and annoying endeavor to non-pimp mobile an 09' Ranger. The project was undertaken because my personal sh** box would not stop bouncing over the smallest of c*** h**** in the road, even after trying two different brands of shocks.
00:00 - Start
02:10 - Tires/Lift
03:09 - Brake Calipers
03:35 - Shock Removal
06:04 - Spindle Separation
05:57 - Spring Removal
08:42 - Spring Installation
09:04 - Spindle Reconnection
11:46 - Sway Bar Reconnection
12:40 - Shock Reinstall
14:30 - Brake Caliper Reinstall
14:51 - End Credits
-------------------------------------------------
Parts used:
* Moog Part Number 80662: Coil Spring Replacement - Summit Racing
-------------------------------------------------
Tools used:
* ~ 90% 3/8 drive sockets/ratchets in you guessed it, Commy Units
* Chisel
* Hammer
* Allen wrenches in, again, Commy Units
* Vertical lifting device
* No smashy stands
* Water
* Motivation
* A will to not roll the dice on a questionable floor jack
* Shout out to those of you actually reading the description
-------------------------------------------------
Attributes:
Slow Burn by Kevin MacLeod is licensed under a Creative Commons Attribution License.
Track: [Electro Swing] Wat Dat Dee [No Copyright Music]
Watch: • Wat Dat Dee - Electro ...
@davidgriffin6724 5 ай бұрын
Oh hell yes, you and I could turn wrenches toghter.
@itz_ypara1233 Жыл бұрын
Thank you so much man this helped me so much it’s well explained and everything unlike the other videos I’ve seen
@shenanigansensue68 Жыл бұрын
No problem bud, glad it was helpful!
@p-riff 6 күн бұрын
How’s the ride quality? I’ve replaced upper and lower control arms, inner and outer tie rods. Kyb shocks, oem coil springs, and Amazon coil springs. Still rides terribly. Slamming over pot holes and jumping around.
@shenanigansensue68 6 күн бұрын
Ride quality was back to normal; so, still drives like a ranger, but doesn't bounce around and bottom out. I put in a pair of moog replacement springs and bilstien shocks.
@dwdeezul Жыл бұрын
hey which spring compressor did you use?
@shenanigansensue68 Жыл бұрын
I used the rental EverTough coil spring compressor through O'Rielly's (Part Number: 67050), but you can buy/rent similar compressors through anywhere. I would've bought one through Summit, but I wanted to get the job done, so I just rented one.
Uncle Tony's Garage
Рет қаралды 200 М.