Thank you for posting this video. My daughter's 2010 Prius took a "torpedo hit" of debris that came flying out from under a big rig at 11:30pm at night that tore up the front under carriage and bumper pretty badly. She did a good job patching it up with black duck tape - lasted for about 2 years, but we finally took the leap and purchased the same bumper - she also has the PCS and headlight washers. Ours didn't have the baby powder on it even though we had it painted to the color of the car - Black, code 202. Your video really helped me with the PCS as many other videos didn't address it. On the passenger side, the retainer clip had been knocked out so I had to figured where to buy them - not too cheap considering the materials - $50 for two was the best price I found. I also discovered that the headlight washer actuators were broken - the covers & nozzles were barely connected and broke off. So I had to find the actuator/nozzle ($40 for both) and clips ($10 for both) for the covers. The covers were OK. Thanks again for posting - the new bumper did not fit exactly as hoped for, but good enough and it looks much better than the duck tape version.

Just another thank you. I had to use your video as the foglight (driver's side) became loose and fell into the bumper cover. The bumper we purchased was not an exact fit for the lighting components and my jury rig solution for the foglight didn't hold. Thanks again for posting!

Thanks for sharing this sir! I ran into a compacted snow bank a couple of days ago and so I'll be replacing the bumper when things warm up. Again, thank you to you and your cinematographer son!

Thank you so VERY much for putting this up! INCREDIBLY helpful! Be Well Shawn L

Thank you for this! Just replaced my bumper today with help from this video.

A few corrections on a otherwise good video - The covers either side of the license plate are for the towing eyelet. - The DRCC sensor is the black square that lines up behind the Toyota emblem. You can tell if a Prius has DRCC by the flat printed emblem instead of a typical plastic badge. - The side ultrasonic sensors are for the parking assist system. LKA uses a camera on top of the rear view mirror slightly offset to the driver side.

thanks. your video helped me a lot 😊

Appreciate the video, thank you.

Is your replacement bumper OEM, used from another Prius or actually brand new made by Toyota?

Where did you buy the bumper at pre-painted and what kind of LED headlights are those?

next time when you remove your bumper, try use anti rust paint on all bolts to prevent it from rusting.