Wish I would’ve saw this video before I took it to the mechanic…well got a new fuel pump and a new connector now

i own 2 vehicles with this motor this worked on both ZIP-TIE wrapped it threw the middle of the pigtail and round the first coil closest to the plug. it was temp. it works so good i found no reason to change. plus i could use the money saved to fix the one of the many other problems.

I've been having problems with my Chevy cutting off while driving and cranking but no start. I took my car to Pep Boys they diagnosed, a catalytic converter and throttle body which came up to 4000$ so I declined. I took it to another auto shop and they diagnosed the coil pack but that didn’t fix the problem. over time it kept breaking down and cranking but did not start until one day I was driving and my car broke down and wouldn’t start so I went under the hood with no mechanic experience and decided to unplug the connector from the coil pack and plug it back in and the car started right up. so the very next day I went on Amazon and purchased a coil pack connector for my Cruze and had it installed and my car has Been running fine ever since.

Thank you for your info i have 255000 miles on my 2011 chevy cruze and have changed everything on it expted the alternator and timing chain , i just changed the coil pack i have not had a problem with the missing plastic clip on the coil pack i will keep my eyes 👀 on it 😊

I’m having this exact problem, I’ll try that

Same exact problems with my Cruze I had 2 stripped threads on the valve cover block I took it to a shop in Michigan and they rethreaded the threads and put in slightly bigger screws. P0171 code is gone no oil spills. Now I'm gonna take it to an electric shop to see if the can depin the ignition coil connector wires and pin it into another connector.

Or you could put clear adhesive silicone glue around it like I did never came loose since I broke the orange peice

That’s not a switch, it’s a connector. Also, “3 of the 71 in-lb bolts have stripped, I guess I’ll replace the entire head” is wrong if you know how to use a helicoil, but ok…

had same issue, ended up being a loose ground right below the coil plug

Same problem i think I'll try the connector idea. Thanks for the video

Put it back on , it's the lock to the connection.

On your stripped out holes there's a company called timesert they sell steel insert kits for every type of threaded hole that you drill and countersink them in it's a steel on steel threaded insert they are bulletproof and you can't strip them out I use them all the time

Grab a pig tail and solder the wireing cost around $25 bucks plus your time good luck with it

I have a connector i cut off another car the locking tab is molded in place i have to remove whats left of the wires with pins frome this one and use it because mine is broke as well

My cruze is doing the same thing

I literally put plastic welder and the car is good for now

You can buy new ignition connector for 20box

Yes zip the the part down

Take the connector off . Slip the catch in place and reattach it

My connecter lock come out and i put it back in.

My air o take sensor sry rotted off so my Cruze has been giving me hell in the winter summer is fine

Where did you get the orangr part

Come on man talk this video could have been half as long if you could get your words out. My daughters Cruze is cranking I can get it to start by working the gas pedal starts fine after it warms up a bit. But I can’t seem to find the problem