2012 Jeep Grand Cherokee Service Suspension Message

Рет қаралды 46,962

Paycheck Monster

Жыл бұрын

I diagnose and repair an air suspension fault on a 2012 Jeep Grand Cherokee.
#Jeep Grand Cherokee

Пікірлер: 37

@movingearth3726 7 ай бұрын

I’ve had my Jeep a 2014 summit break hard … glazed and after a while of drive also have to push more throttle I didn’t have time so the shop it went they said nothing wrong I get it back knowing differently we’ll go figure had the same break shake the front calipers (new) mind you were dragging 9:21 hence the hot brakes

@angelwilliam5811 Жыл бұрын

I need help with mine 2016 grand cherokee summit 4x4 just bought the 2 front suspension bags but it steel stay low on the front???

@CHICOBRUS Жыл бұрын

Saludos el lector salió códigos C2212-00 y C156E-00 favor explica gracias

@Japplesnap Жыл бұрын

Thanks. I have a newer version of that Grand Cherokee and now I know a little bit more about the air suspension system.

@paycheckmonster Жыл бұрын

Thanks again for watching!!

@angelwilliam5811 Жыл бұрын

I have a problem with mine just bought the 2 front airbag suspension but it steel goes down by it self what can it be??

@sixx5552 Жыл бұрын

@@angelwilliam5811 me too bro!!!

@sixx5552 Жыл бұрын

@@angelwilliam5811 my whole Front dropped 😡😡😡😡

@joseamaro3810 Жыл бұрын

Just got mines and I’m already having air suspension problems

@sheerwillsurvival2064 Жыл бұрын

I would have hit the air lift and check it to be sure it’s not a problem with system as when in full lift you aren’t allowed to go over 35- 62 mph It would explained lost of power up hill if the governor system was failing. Seems ok but test drive in lift and out several times.👍🏻 The ASCM also effects braking

@movingearth3726 7 ай бұрын

If you in full lift you are not limited on speed it will just go back to normal mode

@TheDuckieNYC Жыл бұрын

Hi, did it lower and raise before sensor was replace?

@paycheckmonster Жыл бұрын

So it came in low and would not raise because the compressor won't run with that code. It thinks the compressor is overheating and disables it to prevent damage. Thanks for watching!

@duke6024 10 ай бұрын

Appreciate my 2015: overland front suspension is low and rear stuck off road 2 mechanic says need that air pump etc. $850 i think

@paycheckmonster 10 ай бұрын

Thanks for watching!

@m3rdpwr Жыл бұрын

My RAM 1500 says air suspension disabled, cooling down. This is even if I disconnect the battery overnight. I wonder if I have the same issue. Dealer wants $4800 to replace pump and block.

@paycheckmonster Жыл бұрын

If the pump runs for awhile and then displays that message. It almost sounds like it could have a leak and just running too long. That doesn't rule out the pump though unfortunately. I know they are expensive but $4,800. Wow. I haven't priced one out recently, but sounds kinda high. Thanks for watching!!

@m3rdpwr Жыл бұрын

@@paycheckmonster yeah, if it's disconnected overnight, it shouldn't be overheated immediately as soon as you plug it in. If I bypass the relay, it clicks and jumps so it's jammed or burnt out or something. Since it will hold air when it's on off-road too and I disabled the suspension, I suspect that the lines and the air bags are fine. I'm going to take the chance and order the rebuild kit from RMT which includes the pump and the distribution block. I can then just worry about getting it filled with nitrogen. Fingers crossed. Lol

@JS-iu5nc 5 ай бұрын

Just got wuoted $5k for compressor and block. What a joke

@m3rdpwr 5 ай бұрын

@@JS-iu5nc I ended up buying the MX Plus OBD2 reader plus alpha ODB. It told me there was a short in the temperature sensor. Order the new one from RMT manufacturing and it took less than an hour to put in and it was back up and running. $110 for the reader, $50 for the software, $40 for the sensor. All fixed. I did end up ordering a remanufactured pump from RMT, which unfortunately I did not need and they never got back to me about returning it.

@JoseMfly 3 ай бұрын

I have a terrible situation. I replaced the compressor and the shock absorber, now it asks me to reprogram the height. What is the measurement that I should put at the back and front? Someone told me that I should program 80mm at the front and 50mm at the back but I have read that this is a serious mistake because each side of the four is different and causes problems, I no longer know what to do. I have a 2014 Jeep Grand Cherokee Summit and I only replaced the shock absorber and the compressor and I have been stranded for 2 months now, I was even on the verge of losing my job due to lack of transportation, I need help please, please. I have the Alfaobd app to work on the problem. HELP PLEASE, I NEED HELP.

@CHICOBRUS Жыл бұрын

G Cherokee 2012 5.7 4x4 overland

@dechote 11 ай бұрын

Hello What is the name of the part You just replace it I have the same problem In my car Thank you

@paycheckmonster 11 ай бұрын

It's the compressor temp sensor. Thanks for watching!!

@will0014 Жыл бұрын

Where in Minnesota are you located ?

@paycheckmonster Жыл бұрын

See "about" tab on main page for more info. Thanks for watching.

@383dave Жыл бұрын

Probably has hill start turned on

@j.r6656 Жыл бұрын

just subscribed thanks big dawg 🔥🔥🙏

@paycheckmonster Жыл бұрын

Thanks for watching!!

@ekummel Жыл бұрын

If bumpers are designed to "bump", why put sensitive component behind them that can get damaged when they get bumped?

@KitGanji Жыл бұрын

I got into a fender bender in my 15 and it cost me like 5k to replace a controller module and senor in the front bumper for the parking sensors and the shop wasn’t even aware that it was broken. They thought it was just the sensor