Looks very nice with the six inch lift and 37 inch tires. Might look even better on ten inch rims and with the right offset you won't need to spacers at all. I run 35 inch Nitto Recon's on a four inch lift with 20x10 inch rims with no rubbing at all on my 2019 Ram 1500.

Looks great. Wanting to do something similar to my 2014

Looks great and hope mine turns out the same this week when I get 37’s. What are your measurements from ground to top of fender?

Where did you go get those balance?

looks great !..what brand are the flares ? i have these tires .. no complaints at all with them

Good luck with those Ironman tires, one of the worst tires you can get ... out of round and separation problems with those tires .. cupping happens within the first 4k miles .. make sure you rotate them often, I would do every 2000 miles ... used to work for big o tires and these were the worst, had a few who had blowouts with these ... Another thing, go back to a stock UCA, you don't need geometry control arms, that lift kit works only with the stock control arms ... those UCAs are going to increase the issues with those tires big time ... good luck!

Hey Tim! Just wondering if you calibrated your speedometer for better shifting points and easier on the tranny? Or did you leave as is

Are u gonna regear

Now you just need some running boards .

Do you get any vibration at highway speed?