Yes, I was very pleased with the faring from RWD. Glad I can help, thanks for watching!

Thank you, it’s not real hard, but no one else had done a video on it so I figured I might as well. Keep the rubber side down!

@@rosyrosenblum9823 I just put my fairing on this week. It wasn't to bad. I used your fairing video as a guide. I installed 6.5 alpine 2 way speakers, and a 4 channel Sundown Audio SAM 65.4 amp. My head unit is a MTX Bluetooth receiver. Everything is working great so far. FYI If you have not done your audio yet you have to use a speaker with a small magnet.

That sounds great, how does it sound at speed? Also how much did it cost, that’s the only reason I haven’t done it yet

@@rosyrosenblum9823 The entire Audio set up cost just under $400.I am a big time audio enthusiast's So I definitely ended up over spending. I honestly could had done the audio set up for $200 or less. All of my audio test rides have been without the windshield. Audio is nice and clear up to 65 mph. After 65 mph wind noise becomes a factor. With the windshield installed the results maybe a lot better.

I found one on offer up for $75 that included a LED headlight that I sold for $75.😁

If I remember correctly, it was a 12 inch screen from freedom shields. Thank you so much for the kind words, and I appreciate you watching!

@@rosyrosenblum9823 that's awesome, thank you for the speedy response. No problems btw, i enjoy the content you're putting out!

Thanks so much! I appreciate it!

The stock headlight is too small for the Fairing and won’t mount up correctly. It would leave a huge gap in the headlight shell area If you contact RWD, they will tell you the part numbers you need from Harley. But I just found one on offer up Thanks for watching, and good luck, I miss my low rider S

Thank you, I appreciate the compliment. I was so disappointed in the beer, but it was on sale and I thought I'd try it.

I had it painted, it came in black. So if your bike is black you probably won’t need to paint it. Thanks for watching!

You can adjust it up and down about a half an inch. I did not contact the tank with that fairing

I got a little bit of vibration, nothing terrible

The big issue was the Lowrider S headlight shell doesn’t really exist it’s just a headlight so it leaves a huge gap. I honestly don’t know what year it came from, I think I found it on offer up from a guy. Sorry I couldn’t be more helpful with this one, it’s just been a few years and I don’t really recall cause I’m old :-) If you reach out to RWD, Russ can probably explain it better, he was super responsive to me when I was getting my Fairing

All good thank you.

I was, but now I have a different bike

Rosy Rosenblum u sold your low rider s ?

It’s included with the fairing

It’s from clear view shields. To me the 16 inch was too tall and I had to look through it. It was a little bit smoother, maybe 10%.

Rosy Rosenblum did you get the normal 14” or did you have them do a custom one? I adjusted it a bit and got it a bit better, but still wish it was either shorter, or tree the air up better. You should make a comparison video.

Clearview shield had a few 14 inch shields in stock. I’ve had a 12 inch, a 14 inch and the 16 inch. OK I actually had a 16 inch I cut down to 12 inches, but that was too short. 14 inch is definitely the best

I believe the forks are 45 mm. Just email Russ and him or his wife will respond with what you need

You would have to check out the RWD site for specific figment.

yes, i have it on mine. 49mm set up. love it!