No video
2020 Yamaha F150 outboard impeller replacement
Рет қаралды 8,346
3 жыл бұрынTime for annual/100 hour impeller inspect and replace on the main outboard that I’m doing prematurely because I power loaded the boat and it ran out of water approx 30 seconds, noted it took just over 4 seconds for coolant water to discharge and it was low flow when it typically discharges in less than a second, has hard stream. Better safe than sorry.
@shaolinwat Жыл бұрын
Wow, what a perfect video. Thanks for this! In a day and age where everyone ruins videos with useless rants and nonsense, someone's still doing it proper!
@kwikrench Жыл бұрын
Thank you, Thanks for watching.
@torquemarine Жыл бұрын
Unfortunately as a marine mechanic myself, there's a few things that you didn't do properly. 1) you didn't replace the woodruff key, why not? Did you re-use the o-rings? Including the one on the impeller housing? It's actually ok to use a bit more grease in the impeller cup. It doesn't hurt anything. I don't understand why you put grease on the o-ring for the impeller housing? Unnecessary.
@kwikrench Жыл бұрын
Dry land cruising with only 23 hours on new outboard. It was out of the water for 30 sec, didn’t get hot so ordered only the impeller and housing kit, the grease was tacky enough to hold the o’ring seal in place for Assembly. So didn’t need the whole 100 hr parts. I went to flush engine in freshwater and noticed the tell tale took forever and just dribbled, coolant pressure was 1/2 the original especially at idle. Now the tell tale is instant after startup and good stream coming out, I’ve put another 38 hrs on since then. Thanks for watching and commenting.
@ryanvtec3885 2 жыл бұрын
how did the owner blow the pump soo fast just cruising on dry land?
@kwikrench 2 жыл бұрын
You could sorta say that. Mainly the engine so quiet forgot it was running when pulling out of water it ran 30-40 sec out of water, noticed next time on the water the coolant pressure dropped from 16 to 10 and the pee stream just spitting at idle. Temp didn’t get hot but changed impeller and restored pressure. Dry land cruising is no joke. It happens fast. Thanks for commenting
@scottmichael3745 Жыл бұрын
Good video. About to do mine, but why remove the propeller?
@prof1ist 2 жыл бұрын
Did you have it in gear
@kwikrench Жыл бұрын
No. Neutral. Thanks for asking.
@weekileaks23 2 жыл бұрын
I wish I could read your torque wrench
@kwikrench 2 жыл бұрын
If lower unit torque is what you’re lookin for it’s 34 ft lbs on 2020 Yamaha F150. Thanks for commenting.
@weekileaks23 2 жыл бұрын
@@kwikrench thank you!
@semerson8978 Жыл бұрын
What tool to remove the anode?
@kwikrench Жыл бұрын
It’s threaded. There is a rubber plug above. Pry it out and it will expose the bolt.
Replacing Yamaha Outboard Water Pump Impeller DIY Replacement Yamaha 200, Yamaha 175,Yamaha 150 ,250
Out On The Reef
Рет қаралды 400 М.
PartsVu
Рет қаралды 28 М.
PartsVu
Рет қаралды 31 М.