you are the source of my Happiness

very good walkthrough please make a full course! thank you!

Excelente video 👌👏

Please tell me how to assign ID to each slave mode

when i am debugging the code using STLINK an error is coming as STMicroelectronics ST-LINK GDB server. Version 7.7.0 Copyright (c) 2024, STMicroelectronics. All rights reserved. Starting server with the following options: Persistent Mode : Disabled LogFile Name : P:\stm32_projects\bootload\Debug\st-link_gdbserver_log.txt Logging Level : 31 Listen Port Number : 61234 Status Refresh Delay : 15s Verbose Mode : Enabled SWD Debug : Enabled COM frequency = 4000 kHz Target connection mode: Attach Reading ROM table for AP 0 @0xe00fffd0 Hardware watchpoint supported by the target ST-LINK Firmware version : V2J45S7 Device ID: 0x4c3 PC: 0xa ST-LINK device status: RUN_MODE ST-LINK detects target voltage = 3.19 V Error in initializing ST-LINK device. Reason: ST-LINK: Could not verify ST device! Abort connection.

I have a couple of questions about sending data another IC can you share your telegram or e mail or Skype to ask something.If it is not possible my question is how can send anolog value another STm32 i tried but mostly each value example 22 value coming like 50 50 two byte coming independently ASCII value but I need value not character.