My method for leak detection is simple. First, I identify what would be the worst possible place, in terms of ease of repair, for a leak. That's where I start. 9 out of 10 times, that's where it is. I let my shitty luck work for me 😅. I'm going to have to get one of those fieldpiece units, and give it a shot. Thanks for the video 🤘

Same small rooms in Memphis, Tn. They usually throw in a 1500 pound self contained ice maker for that sauna effect. Then they say things like "it doesn't make as much ice as it use to". We just smile. Enjoy the day Dave.

I like using the INFICON. It does a good job. Haven't tried the Fieldpiece you have, though. Great video once again! Love learning from you, Dave.

If bleeds, I can find the leak! The Field Piece for the win! Good job Dave!

Worked on many Hobart/ Traulsen units. Replaced many evaporators, TXV' S, and hot gas drain pan loops. Made many out of a coil of 1/4" copper tubing.

I have a battery charging party every sunday. Its an all day affair

Yes has been very busy

Killed my H10 on friday after I turned it into a water fountain... Think it was just shy of $400 to get a new sensor shipped here, plus no doubt I'll get stung with import charges!

Crazy busy here in the panhandle of Florida...over a 100° everyday... ac's suffering everywhere!

Predator blood. 😂 got a chuckle from that statement

Looks like a lime snow cone haha

No problem with bandaids if you got big nostrils 🤣🤣. Just bought a Accutrak Ultrasonic with the noise canceling headphones. It works unbelievable well to listen for the leak especially in multilayer coils. Nice job Dave

gotta love that dye!

Great Video Dave! Got to love the predator blood. Funny you were talking about drilling your finger. I did the same thing this week putting the compressor cover back on an old Rheem RTU. Bled like a stuck pig.

❄️👍🇺🇸💪 watching 9ers first drive Purdy looks good

in this video Dave shows how hard he screwed his finger! 🤣🤣 ouch, ran screws into mine before and got many metal pieces cast off them, but never ran one in deep. I have stabbed in a drill bits and screw drivers before of course, little slip and OWW 😳

👍👍👍

finally cooling off in Minnesota

1dr traulsen units are so tight to work on. I like the 2dr and 3r units. But they gotta do something with the way to access the evap. Everytime you open the top cover its a pain in the butt.

thank you for great videos

❄️👍🇺🇸💪 thanks Dave Go birds

Hi bro from west Alabama

Inficon for sure is better than the new Fieldpiece Dr 58 in my experience can't speak for the older Fieldpiece

Finger drill violation 😁😁😁

PersonAl foul on the impact gun automatic 1st down repeat repair . Predator blood Lmaso 😂😂😂😂😂😂😂😂😂😂😂

That drain pan looks suspect

Thanks Going to charge some stuff

They have an exhaust but didn’t see a place for air intake when the door was shut…

👍🧿

You had it in low sens on dtek

Don't do that that's was scary ha ha

Once again the SLR8 defeated the Inficon 🗑️🤷🏻‍♂️. Evaporator, TXV , and condensate loop to be on the safe side . Pay the fat guy lady 😃😀

How do that gauge calculate SH SC without clamp on probes?