3D Puff Embroidery On a Structured Snapback Hat Using Ricoma Marquee 2001 (Beginner Learning)

No video

3D Puff Embroidery On a Structured Snapback Hat Using Ricoma Marquee 2001 (Beginner Learning)

Рет қаралды 1,317

4 ай бұрын

In this video I show you how to use the Ricoma Marquee 2001 to make a snapback with 3D embroidery.
If you would like to further support my channel, checkout my webshop & affiliate links below. If you want to schedule a 1-on-1 consultation with me, visit my webshop and go to "digital products."
Webshop
ikendoit.shop
Link Tree
linktr.ee/iken...
My Equipment List (All links below are affiliate, it simply helps me run my business and supports my channel, the prices are all the same whether you use it or not. Thank you!)
Ricoma Embroidery Machine
ricoma.com/US/...
Ricoma Accessories & Other Products
shop.ricoma.com?referral=iken-doit
$10 Design Assets: ikendoitdotstu...
My Home Setup Equipment List
shrsl.com/47e49
Heat Press 16x20 Auto w/ Sure Pressure
shrsl.com/46hnu
BRICK 600 HTV
shrsl.com/47wak
Heat Press Nation Splitter
shrsl.com/4dcpi
My Vinyl Cutter (Cameo Silhouette Plus 4)
shrsl.com/455jn
My Favorite Puff HTV (Use Code ikendoitstudio for 10% OFF!)
econotransfer....
My Favorite POD (Print-On-Demand) Vendor
www.printful.c...

Пікірлер: 5

@user-ve8ne6uy2w 3 ай бұрын

Great Job. Congratulations on your new Ricoma. Just some quick advise. Caps should always be done at a lower speed. It will help insure registration and help avoid breaking needles at high speed. Your input about the 80/12 needles was great as I've had issues with 3D puff cutting away as clean as I would like. Solvy™ is a water soluble film used as an embroidery topping on high-pile fabrics. When used as a topping on knits, terry cloth, fleece and other textured fabrics, Solvy™ creates a smooth embroidery surface to give clearer embroidery. Stitches won't sink into the fabric, giving a crisp definition and detail to your work. Like anything else there are good brands and some cheap brands. figure what works best for you and do your thing. Welcome to the market place.

@ikendoitdotstudio 3 ай бұрын

Thank you! I have been running my hats closer to 500-600 since this video, and I also started using a firmer puff and it's done wonders to my designs. I guess the stuff on Amazon isn't so great, or I haven't found the right stuff. The Madeira Body Builder one is so much better imo for 3D work. Can't wait to continue to explore and learn more!