42RE Teardown

No video

42RE Teardown

Рет қаралды 1,567

Күн бұрын

In this video, i teardown a 42RE out of a 1993 jeep, car did not move. Also, during the rebuild i updated the electronics in the unit. Thanks for watching.

Пікірлер: 20

@whatwasthat3269 5 ай бұрын

Thanks Gary. Im ready to do my 44re in a 98 grand cherokee. Im getting rotational noise from the planetary area only in motion. Thank you for the info about the tab washer on the planets. Im gonna order a new one.

@Minivan_Man 5 ай бұрын

Nice, there won't be anything sturdy, reliable and thankful material today as it was back then. Thanks for sharing 👍🏻

@oldschool9746 5 ай бұрын

Thank you Gary for another fine video !

@HUMPBAK 5 ай бұрын

This transmission brings back soo many old memories of mine .. this transmission was on top in kuwait, once upon a time .. and back than i used to work as a child labor

@dieseltechjoe 4 ай бұрын

I've had one come in, guy paid teens to install a junyard unit in. Didnt reinstall the dowls and shattered the pump gear. I still have that transmission and went though it. If they would have installed the dowls probably would have been a good one.

@autogeartech9436 5 ай бұрын

Great job ❤❤

@TheHoota101 5 ай бұрын

Hope to see the build video of this unit

@GaryFerraro 5 ай бұрын

I do have a rebuild video on this trans

@whatwasthat3269 5 ай бұрын

Yes I just watched those build videos , excellent thank you.

@igotaction 5 ай бұрын

Hat tip to the person rebuilding a 93 Grand Cherokee trans.

@vengefulwolf2226 5 ай бұрын

Do you have a video on a 545RFE rebuild?

@JohnTaylor-aftrwjt 5 ай бұрын

Do you have any teardown and rebuild video's for the 44re. I have a 97 Dakota 4-wd and I think that's what it may have in it.

@GaryFerraro 5 ай бұрын

yes both, the rebuild video may be a 42RE but same thing

@LJwhisman9695 Ай бұрын

I have 95 grand cherokee zj i rebuid the transmission and then replace all the sensors in it and torque converter its stills down the same thing in 2 wheel and 4h it goes to high rpm when on incline wont move but on flat it will but in 4 low it move around like nothing wrong it still back up in all normal can you help i thinking its the transmission pump

@GaryFerraro Ай бұрын

will it move in manual 1, if so sounds like a bad sprag

@LJwhisman9695 Ай бұрын

@@GaryFerraro in 4 low yes 2 high and 4 high no it won't and would it be the one at the back of the case or in overdrive I know it has two

@GaryFerraro Ай бұрын

@@LJwhisman9695 one in the back of the case

@LJwhisman9695 Ай бұрын

@@GaryFerraro ok thank you