4X4BROTHERS AIRBAG MAN DIY INSTALL INTO A NISSAN Y62 PATROL AIR TANK AND COMPRESSOR

Рет қаралды 8,407

Күн бұрын

In this video I show you how i installed and setup the airbag man load assist air bags into my y62 patrol, complete with air tank, compressor and wireless monitoring. This is my first shot at a install video and would love your feedback. Leave your comments in the comments section and let me know your thoughts

Пікірлер: 31

@racinsadventures597 5 жыл бұрын

Great work super star !! 💥

@4x4brothers 5 жыл бұрын

Thank you legend

@steve_ohhhhhhh 5 жыл бұрын

Great job 👍🏻

@4x4brothers 5 жыл бұрын

Thanks buddy 👌

@bradrein08 5 жыл бұрын

Nice work mate. Side note what is that battery gauge u are running? Looks good. Cheers. Keep it up

@4x4brothers 5 жыл бұрын

Thanks mate. Battery monitor is a simarine does also water tank levels, gas bottle levels, temperature sensors etc as well

@adamsurf76 3 ай бұрын

Hey mate great vid just wanted to ask what was your max height when inflated compared to deflated from top of rim? just curious to see if mine is similar :)

@4x4brothers 3 ай бұрын

Cheers mate. I’m not to sure the measurements now been a while since making this video. Would have to measure again

@aaronclausen654 Жыл бұрын

Great video thanks! Hey did you need to loosen the bolt to drop your suspension lower arm or did you simply jack up the wheel and let it droop naturally without undoing anything?

@4x4brothers Жыл бұрын

Cheers mate, nope didn't need to un bolt anything. Plenty of space with just suspension droop

@MudducksTouringAustralia 5 жыл бұрын

I reckon I need a set on my 200. Cheers Steve

@4x4brothers 5 жыл бұрын

Super easy to do mate hope this helped in some way. 🍺

@cameronmayer9317 3 жыл бұрын

Awesome video mate, very helpful doing mine soon! How does the single compressor go for pumping up the tyres? Do you think it would be better to get dual compressors? Or is the single fairly efficient? Cheers!

@4x4brothers 3 жыл бұрын

Cheers bud, bigger is Definatly always better but for what it is it's no worries pumping up the 35s it's quicker than Mick pumping up his 33s with his thumper compressor. If I had the room I'd maybe put some thing a bit bigger in. If not more than happy to recommend this one.

@cameronmayer9317 3 жыл бұрын

Thanks Dave! That’s all I needed to hear.👌🏽

@timbd87 4 жыл бұрын

Great video! What drawer setup did you go with? Or custom made?

@4x4brothers 4 жыл бұрын

G'day mate thanks for watching. It's actually the 4wd super centre draw system but then pulled it apart and made my own top and wings and re carpeted it all i didn't like the blue

@timbd87 4 жыл бұрын

@@4x4brothers Nice, thanks for the reply, looks ace!

@4x4brothers 4 жыл бұрын

Cheers mate does the job nicely and was budget savy till I knew what I wanted but this will stay now it's working

@LVNITUPM8 5 жыл бұрын

Airbag man recommend that you inflate airbags before you load up the car and if you have rear drawers they say jack the car up inflate a bit then put back down

@4x4brothers 5 жыл бұрын

Ah cheers for the tip mate I'll have a go at that method. Any idea why inflate before loading up and how do you know how much pressure to put in before the load is in the car?

@LVNITUPM8 5 жыл бұрын

@@4x4brothers it's to do with the airbag not getting pinched by the spring when it's compresses. If it's inflated first it stretches the spring where as if you load up the inflate the airbag bulges out in the spring gaps and having the chance to pinch

@LVNITUPM8 5 жыл бұрын

@@4x4brothers I pump mine up to 20 to 25 psi depends how much am loading up in the rear and I always keep 8 psi minimum because I have drawers in the rear and 2 fridges at all times

@LVNITUPM8 5 жыл бұрын

@@4x4brothers I would say start at the 25 psi load it up drive around see how it goes for ya and then you can always let bit out until you find the right pressure that works for ya

@4x4brothers 5 жыл бұрын

Yeah nice makes sense will give it a go cheers mate