6L80E Pressure Regulator Valve Vacuum Testing.

Рет қаралды 7,371

Күн бұрын

Пікірлер: 22

@arthurfricchione8119 2 жыл бұрын

Thanks for sharing. Watching other transmission videos they show tearing one down but they rarely show the actual testing. Thanks for sharing your info and knowledge Artie 👍

@mechboy5954 Жыл бұрын

What a great video demonstrating before and after values

@kuruppujayantha8828 Жыл бұрын

Nice video

@tomstrum6259 2 жыл бұрын

Thank you for sharing this great Diy video !! I needed to acquire an Affordable calibrated vacuum test meter & your video helped tremendously !! Great channel content...Thx,....tom.

@playharder1435 Жыл бұрын

A pencil eraser works perfectly to plug orifices on the valves 😊

@Markakis90 2 жыл бұрын

Nice video bro

@donaldisrael7147 2 жыл бұрын

Thanks for the demo. I guess there's no way to ream the bore and use an oversize valve.

@AutomaticTransmission 2 жыл бұрын

Go to sonnax website, for every valve that they sell there's a minimum vacuum standard reading. If it's within specifications you'll put a drop in valve. If it's below you ream.

@scottdavis3289 Жыл бұрын

What are the symptoms of a failing pressure regulator valve?

@alfonsoferguson290 2 жыл бұрын

I would like to know where u are located I have a 2014 silverado that is starting to have transmission problems

@marknaravas318 2 жыл бұрын

Hiram: do you know of anyone that has an oversized valve and bore reamer for the 80?

@SnowCamo45 Жыл бұрын

💯💯💯👍🏽

@nickmiller7477 2 жыл бұрын

I've got a question for you

@Steve.191 2 жыл бұрын

Would readings be different if hot transmission thanks 👍

@AutomaticTransmission 2 жыл бұрын

Yes since the fluid gets thinner and metals expand with heat. If you notice I have the valve clean and dry, fluid would give me a better reading since it covers the wear somewhat.

@alfonsoferguson290 2 жыл бұрын

Where are u located

@OTB_CHOP 2 жыл бұрын

By any chance what’s the name of your shop or email I can reach you at?

@vs68s39 2 жыл бұрын

How to determine the bore is worn too much

@AutomaticTransmission 2 жыл бұрын

Go to sonnax website, on every valve they sell there's a minimum vacuum standard. If it's close to it or slightly below you can install a drop in valve. If it's way too low then you need to ream it and install an oversized valve.

@vs68s39 2 жыл бұрын

@@AutomaticTransmission Thank you.