thank you, u got no idea how many hours of old toyota videos ive put in to look for this one piece of advice thanks alot
@jiaweizhang41032 жыл бұрын
You're welcome! I'm glad it helped!
@DIYMechanic2 ай бұрын
This is actually caused by leaking electrolytic capacitors. There is 2 on the other side of the board that should be replaced. Then you need to clean off the copper tracks and use a multimeter to check for any broken tracks that need jumper wires
@richardsimmons78102 жыл бұрын
Hi! I just follow your suggestion , now it’s working I had that problem a long time .
@jiaweizhang41032 жыл бұрын
Glad to hear!
@PedroKolbEmmel2 жыл бұрын
Thanks!!
@dassaaguilar9055 Жыл бұрын
What can I clean it with? I have that problem? do i just clean it or sand it?
@muasboy Жыл бұрын
Fcken genius!! Thank you
@Jeff-iu7wr2 жыл бұрын
How would you clean the oxidation? Mine is the same but different cleaning methods have not gotten it all off
@Jeff-iu7wr2 жыл бұрын
Also did the one you got have soldering completing the bridge between damaged copper sections?
@erwinyulip4373 жыл бұрын
Can you help me.. My car doesnt work speedometer and odometer. Do you have any idea sir? Thankyou
@ncshorty113 жыл бұрын
And did this truck have a speedo cable Or sensor ?
@jiaweizhang41033 жыл бұрын
Sensor.
@ncshorty113 жыл бұрын
What did you solder ?
@jiaweizhang41033 жыл бұрын
I didn't actually do it. I pulled one from a junk yard and somebody has already repaired it. So I'm just conveying what I saw. And what he soldered is a little hard to describe. It's basically the entire top and right edge of what's shown. A good rule of thumb is once you've cleaned everything, you can just follow the copper underneath. You can also use the black corrosion as a guideline.
@jaytyree692 жыл бұрын
Does it also work on the tach
@jiaweizhang41032 жыл бұрын
This particular year and model has no tach
@4af Жыл бұрын
doesn't show what to clean or how to clean. doesn't show what to solder or how to solder.