Makita 40v works fine

Bosch is useless. Tighten one bolt and the battery overheats. Happens every single morning

@@user-gn4uk1jv3c what bolt you tightening in the morning mate 😁😁😁😁

@@user-gn4uk1jv3c you need to know what the tool is rated for before spreading non-sense

@@user-gn4uk1jv3cnever had any battery overheating, when im from Central Europe using normal as well as procure batteries in impacts and 8x400 screws where there is definitely the limit so don’t talk shit wenn u don’t have the knowledge i have. Overheating the batterie is impossible in nearly every possible way.

@@henninghertlein79 bosch batteries are arse

Makita and Milwaukee go fine in wet weather, I've dropped two makita impacters in a body of water on two separate occasions and they never had any problems, one of them was in a tank for a good 5 minutes and worked the moment I pulled it out

Not all Hikoki tools are IP rated, just some of them with the IP sticker on.

Gatorback makes a decent budget belt. The whole belt is about $200 CAD not including the suspenders. Obviously tax and shipping varies

Build Pro in Melbourne

Just swapped to toughbuilt 5 piece framer set up with suspenders for like $200. Durable and super comfy, and the clip lock function has been such a game changer. Integrates beautifully with the pack out stuff too.couldn’t recommend more for the price.

That's a second big thumbs up for Buildpro! Excellent build quality and comfortable all day! They do leather frogs as well as nylon (in my opinion is better)

Could buy a diamond back or badger second hand on market place if your lucky

For some reason he is pushing down on the battery when using the rotary hammer, this is pushing the battery away from the terminals and not allowing the battery to move along with the floating terminals. This causes a poor connection and higher current and heat resulting in the safety mode activating, a flash on the last bar would have indicated that the battery was actually flat, no lights is a fault. Also on the Bosch batteries the red plastic at the base is part of the heatsink for the cells, if they get hot you can definitely feel it. However it still might have not done many more holes.

This is more of an impact wrench that can double as a compact impact wrench. It might do 16mm x 100mm screws in concrete but don't expect much more out of a 210Nm tool

Throw some grease on those screw bolts and even the dyna bolts. They will drive in easier and and give some protection from the concrete rusting them up. Can be a bit messy but your a stickler for quality. You will be knocking back work . Well done.

He is the boss 😂

@@camoz123 he stated in earlier videos he sub contracts for someone.

@@glenndfidthis build he is working for himself. He usually states in his videos if he’s contracting or not and he also informs those he’s contracting for about his KZfaq and whether or not they allow him to film is purely up to the contractor.

He is testing a 10 piece kit from Bosch and only using the batteries that come in the kit. All the brands tend to put the low end or old models in these kits.

@@slinkytrips true and people and those testing tools for hobby still don't understand that those are not the best tools availible. For example, impact driver that has ability to be small impact wrench too, is not meant for large concrete bolts. Bosch has great impact wrenches in it's arsenal for such puprose.