Thanks for taking the time to explain this amazingly efficient subprogram routine! I can't believe I overlooked this :o
@darrenvosper6344 жыл бұрын
With a small edit to the post for HAAS users you can edit the post to call internal subs M97's and not external M98's.
@mackenzebowles87334 жыл бұрын
That was very helpful, thank you
@ThomasShue3 жыл бұрын
What tool-path is transform translate rectangle. I see that folder in the tool-paths stack and you clicked on parameters to change stuff. My question is what was the name of the toolpath that allowed you to add that transform/translate rectangle I wish you would of showed how you got to the point of going into the parameters and selecting sub programs
@manjunathans32502 жыл бұрын
For each and every (depth of cut) it calling the subprogram, How to use L value in it.??? For Ex. Total depth is 5mm, (DOC 1mm), then (L=5). This will reduce still many lines, size. But how to use it in cam??
@hienaz7234 жыл бұрын
Nice good to know
@nc4uservices-cnctrainingco7082 жыл бұрын
How to edit subprogram L value visible in post processor