installed new bearing SKF in motor because bearing noise more high when we are open the motor found water in motor ,but motor was running ok and no short circuit ,
Пікірлер: 21
@ahmedshaker3433 жыл бұрын
This is a very good example of how not to replace motor bearings ...
@kazemmousa12 жыл бұрын
😂😂😂
@Hestherelaa2 жыл бұрын
🤣🤣🤣🤣🤣 whack them off! And wash with water
@hosseintaherimoghadam11752 жыл бұрын
Thanks for sharing this video.good luck
@60478743 жыл бұрын
New SKF roller bearing Made in Malaysia on the pack. Should have heated up the pulley before pushing it into the shaft, violent hammering not recommended.
@mateuszdolasinski5233 жыл бұрын
OMG! :O At least it works...
@dbantendinamochannel66372 жыл бұрын
Hasil mantap
@swetagupta48433 жыл бұрын
Siemens, ABB, CG ki motors best hoti h
@hosseintaherimoghadam11752 жыл бұрын
This can be done better with better tools. In addition, with the impact and improper tools, the sealing parts of the bearings are damaged and again cause premature damage.
@khanengineering47874 жыл бұрын
V good....
@manoranjan45983 жыл бұрын
Nice sir
@liaamelia20663 жыл бұрын
Brutal.. No tracker
@amedhossain60322 жыл бұрын
very good job..
@sjaman95993 жыл бұрын
Assalamu walaikum. Abb. 3phase.5hp.1425rpm.ki rewainding. Data plz dijie.
@ahmedshaker3433 жыл бұрын
WHAT IN THE WORLD IS GOING ON HERE !
@hamcafaraceman81792 жыл бұрын
اصلا عملکردتان خوب نبود بخصوص جا زدن بلبرینگ 😐😕
@juju-dd2bu2 жыл бұрын
what's this?
@trandung81094 жыл бұрын
there are always have another better solution . Assembly bearing as yours way , sorry it not make pleasure to say : properly .