Visit our Facebook page : Brainlimbo?m... DISCLAIMER: This video is for entertainment purposes only: I am not an electrician, plumber, or professional to give you advice. I'm just sharing my experiences and research.
Пікірлер: 31
@richardmullings16 күн бұрын
You are the best
@socheatfishing25028 ай бұрын
Good job 👍 Thank you very much for sharing bro ❤
@YoAdrian20914 күн бұрын
Your a lifesaver great video! Now i just have to figure out why my car door locks dont work. Any idea what it could be?
@khmerohio13 күн бұрын
@@YoAdrian209 check relay
@gardud72 ай бұрын
Do you know where I can find the correct harness? I have a 2013 acura tsx special edition
@omarstyle79478 ай бұрын
If you could show me what you do a little closer i could figure it out for myself
@arestox5 ай бұрын
So the White Wire from the OEM harness have to be connected to a 12v Power Wire in the head unit or it has to connected to the rca harness AMP wire?
@khmerohio5 ай бұрын
You will need to hook the blue/white from the stereo to the white wire of the oem
@khmerohio5 ай бұрын
Don't hook the white wire to a 12vt constant it will run your battery down because the amp will stay on
@arestox5 ай бұрын
@@khmerohio thanks i'll check that.
@arestox5 ай бұрын
@@khmerohio hmm so i checked, but i have a green wire on the rca harness (from the head unit). And i have two white wires in the harness from the Car.
@arestox5 ай бұрын
@@khmerohio i solved my problem, i connect the amp wire from the rca android harness to the White (#17) factory harness. All OEM speakers, tweeters + sub works like a charm. I also activate "AMP On" in the Radio settings.
@zachbolen97934 ай бұрын
So how did you make the Sub work without hooking it up?
@khmerohio4 ай бұрын
I am not sure what you're referring to, but if you send a signal to the factory turn-on wire, the sound (factory sub) should work
@omarstyle79478 ай бұрын
you can't send me a diagram or a pic of the wire harness where the blue wire connect too
@omarstyle79478 ай бұрын
I install my Android radia on my 2009 honda accord cu1 there is no sound
@khmerohio8 ай бұрын
In the back of your radio, there is a gray 24 pin plug. Connect the red wire of your android to pin 17 White wire
@omarstyle79478 ай бұрын
I did that, but still no sound
@Cire877 ай бұрын
So I'm having similar issue. I have a pink wire AMP-C and I connected it to the blue AMP-CTRL wire, I got sound but it drains the battery. Any advice?
@khmerohio7 ай бұрын
It's depend on what kind of stereo you have usually the pink wire is the reverse or the key one wire
@Cire877 ай бұрын
@@khmerohio It's an Android one I purchased off ebay. I'm trying to connect it to my 2014 Honda Accord. Also, the pink on is the AMP-CTRL and the blue ones is the AMP-C, my mistake but when I connected those together, I get sound but my AMP is constantly getting power which kills my battery.
@khmerohio7 ай бұрын
There's a blue wire in the i think 16 plugs with all those RCA output. There's a blue wire, is that what you are using?
@Cire877 ай бұрын
@@khmerohio No, the blue wire is coming out of the 24 pin connector that's no connection to anything. The pink one is coming from that 16 plug one with all the RCA cables. Connect them together, when I touch those two together when my car and everything is turned off, I hear a popping noise and if I leave them connected it drains the battery.
@khmerohio7 ай бұрын
I just watched my video again. The white wire is the remote turn on
@raygangibbs37626 ай бұрын
It worked but my audio is low, I have the same radio and car