Adding DR.DRO and Servo Motor to Grinder Work Head! Boost Your Tool Cutter Grinder! (Part 1)

Рет қаралды 898

19 күн бұрын

Finally getting ready to use my DRO on the Cincinnati No.2 Tool Cutter Grinder!
In this episode I'm going over the installation and configuration of DR.DRO for grinding applications. At the end of the episode we will have a good understanding of how DR.DRO works and we will be able to perform direct indexing and axis follower operations!
I've got plenty of stock if you're interested :)
Support and stars on Github are greatly appreciated! It will help in keeping this project going!
Visit the Github repositories:
github.com/bartei
Visit the home page:
www.provvedo.com
Thanks for watching!

Пікірлер: 13

@klab3929 17 күн бұрын

Subscribing from RotarySMP, keep it coming! :D

@stefanobertelli2650 16 күн бұрын

Thanks for subbing!

@joell439 16 күн бұрын

👍👍😎👍👍

@RotarySMP 17 күн бұрын

Hi Stefano, Good timing for a new video. I have a video coming out in 3 hours with a shoutout to your channel. :) Keep up the good work.

@stefanobertelli2650 17 күн бұрын

Awesome Mark! It sure takes a lot of time to edit the videos, I'm still a long ways from your level :) We need to get a DRO mounted on your Clarkson!!!

@RotarySMP 17 күн бұрын

@@stefanobertelli2650 How do you dial in your end mill flute spiral? My mates mechanical Heller has an infinitely adjustable angle (conical friction drive) so you put a clock on a flute and just dial the angle till you get no movement on the clock. You could do the same with an jog encoder input to set the ratio.

@stefanobertelli2650 17 күн бұрын

@RotarySMP part2 of the video will show exactly that, the naive approach i took for this quick demo was just trial and error with a dial test indicator. The monoset manual suggests a clever way of doing the helix pickup that i will show in the upcoming videos as well.

@RotarySMP 17 күн бұрын

@@stefanobertelli2650 Cool. You are doing a great project there.

@RustyInventions-wz6ir 17 күн бұрын

Very nice work sir

@stefanobertelli2650 16 күн бұрын

Thank you!

@LCalleja 17 күн бұрын

Grate video and just in time I am just going to get it setup for hobbing today :) One application where you would need to synchronise to two axis would be for helical gear hobbing I might also have to give that a try. Thanks always enjoy your videos

@stefanobertelli2650 17 күн бұрын

Thanks Luke! You’re always too kind :) let’s get your clarkson equipped with the dro!

@LCalleja 17 күн бұрын

Yes can’t wait to pimp out the clarkson but I need to get some scales first. Then build a decent work head for it so still a fair bit of work to do