Рет қаралды 1,976
ADNOC New WMS Procedures.
Candidates with the underpinning knowledge, to be able to understand their roles and responsibilities when planning lifting operations, making risk assessment and lifting plane as per current local / international and client regulations.
MINIMUM QUALIFICATIONS OF A NOMINATED PERSON:
The minimum qualification that the participant must have are:
Have had adequate training experience and be competent to act as an appointed person or focal point nominated by management to be in over-all control of the lifting operations. Be educated to a minimum of secondary level and be experienced of not less than 5 years in the same area of application to carry out the same job..
Have a good command of the English language
Have strong administrative and supervisory skills to schedule, monitor and control the "lifting equipment" personnel lifting operations.
Rigging and Slinging:
Rights and responsibilities
Terms and definitions of various lifting/rigging terminology
Introduction to various types of slings (webbing slings, wire rope slings and chain slings)
Pre-use inspection of various types of slings
Rejection criteria of lifting accessories
Types of lifting hitches
Sling angles
Determining the slings capacity
Types of Shackles, eye bolts and hooks, chain block , turn buckles and their inspection
Proper lifting techniques
Communication and Hand Signals during Lifting
Hazards associated with lifting and cranes work
Lifting & Handling General Principles
Crane Operation:
Types of cranes
Illustration of various components of cranes
Proper set up of cranes
Introduction of various types of cranes
Safety precaution during cranes routine work
Pre-use inspection
How to read and understand the load charts of various cranes
Stability of cranes and factors that affects the stability and strength of the cranes
Introduction for using the RCI/LMI
Lifting Plan
Categorization of lifts
Rules and responsibilities of personnel
Risk assessment
Method statement
Setting up- cranes and ground condition
Calculation of loads weights
Calculation of slings capacities in relation to their angles