Glad I could help. Hopefully I can start making videos again soon I've just been super busy since I moved from GA to NJ. Left my collection in storage down south and haven't bought anything new in a year. Ultimately my goal was always to help people. My Instagram link should be in the description I love it when people send me pics of what they've been able to make and I'd love to see your Batman. Later

@@609collector it doesnt even compete with the stuff youve got on there, this is my first time modifying a figure so its probably as good as itll get for now thanks again

@dr_busa_nutts we all start somewhere. I started watching Craig Warrick and Glenn Webb R.I.P. . These guys are goat's

@@609collector ill definitely check them out and some of your other videos next time i give it a shot

When I have to use pliers I fold up a paper towel and sue it as a buffer

I just looked at it after reading this. It is a bit lower but it doesn't cause any issue. I most likely didn't push it in far enough. Figure stands fine and is still tight

@@609collector Cool, thanks!

Boilin

Hey, my Instagram link is in the description. Message me there, and I'll see if I can help you.

Heat it up with really hot water and try to pry it out. Small flat head screw driver, tweezers or a needle may work. Just take your time and be careful not to warp the figure. Also be careful not to stab or cut yourself. Heating the wrist will make it easy to soften the plastic and get inside the wrist. If it gets a little out of shape you should be able to squeeze it back in to shape but I would recommend not applying too much force so you don't widen the wrist so much a new peg won't fit. Good luck

@@609collector cheers. You wouldn’t happen to know if McFarlane issue spare replacement parts for figures that arrived damaged? The plastic moulding of his left hand was cracked when I opened it :(

@Jimmy Volakis I wouldn't know. It never hurts to reach put to customer service. If they can't help try ebay and if no luck reach out to the action figure community on Facebook and Instagram. There are always really cool people willing to help out fellow collectors with advise, parts and tips. Maybe someone would know where you could find a good replacement is McFarlane can't help, or maybe someone could hook you up. Good luck

@@609collector yes cheers for that man! I’ll have to look around

Lmao got myself as azbat for a custom too

If it's just painted on ibthinknyou can use nail polish remover and a q-tip

@@609collector what about if its sculpted on?

That will require you to think outside the box. You could sand it down, sculpt over it, or swap out for another upper torso that meets the same needs but requires less work.

@@609collector someone else told me to put it in hot water so ill try that instead of sanding it or sculpting over it. i dont trust myself enough for that

When the water boils its hot enough. Soak the figure for 1-2 minutes and that's all you'll need.

@@609collector thank you sir

Thanks for watching

@@609collector your welcome

Not exactly sure what you're looking for. I will say 2 things. 1. The wrist pegs in the hand pull out just like the ones in the feet. They're the simplest joints on the whole figure. As I stated one of mine broke right out of the box so I dint want to pull them out and have it fall apart. 2. If no one shows how the shoulder comes apart it's because it's not meant to. Not sure how it's sealed but that peg coming out of the shoulder is just meant for up and down motion and it allows for 360° turning, that can be seen just by looking at it. The shoulder roll motion comes from the ball peg, which I showed. I'm not sure what you're looking for or why you'd need more but some things aren't meant to come apart. If you do cut one open I'd love to see what's in there myself.