Video on how to install Alpena aftermarket wheel covers on any vehicle. In this video I am installing 18 inch wheel covers on steel rims. This video should apply to most aftermarket brands as they are all similar.
You will have three parts from that come with each wheel cover (wheel cover, metal ring and plastic ring connector). To start you will want to connect the metal ring using plastic ring connector. There will be three different holes (sizes) you can select depending on the type of your steel rim.
Once that is done you will have to clip the metal ring inside the wheel cover. Again you will have two different ring slots (upper and lower). That will again depend on the type and size of your steel rim. So you will have to adjust it the best way to be nice and tight on the rim. Once installed it is a good idea to gently tap the wheel cover all around to make sure it sits in place.
If properly installed wheel covers will not move or fall from the rims.
Thanks for watching.
Don't forget to Like the video / SUBSCRIBE to the channel!
⚠ DISCLAIMER:
While QuiteAlright strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. The videos are intended for information only. Follow the manufactures repair procedure and use appropriate safety procedures. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. QuiteAlright is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.