Preparation of connection equipment, drilling operations. Sanding of wood.
To support: www.patreon.com/ahmetcakir
Wooden House Construction Part 1 Preparation and Foundation: • Yeni Bir Hayata Merhab...
Wooden House Construction, Part 2 Foundation Concretes: youtu.be MelbouruLnbIE74eE
Hello to a New Life, A Challenging Start: • Yeni Bir Hayata Merhab...
Video Text:
Yesterday I opened the woods because the rain had recovered, I was thinking about continuing to work today. But it started raining again, it rained down, I covered a certain part of the wood, but they were already wet. I hope nothing will happen.
I want the weather conditions to improve now, I can't go this way, I hope the sun goes up today.
I started drilling the profiles for basic and corner connections. I'm drilling holes in 4 sides, 2 in each side. I'm drilling 2 holes in 90-degree corner joints.
I'm torturing him in case he gets stuck while turning a hole. Thus, even if jammed, metals do not rotate, which may break the tip or break your hand or foot, so it is safety first.
When drilling holes, you need to drill with a small 1mm drill bit when drilling concrete and with a 1mm large drill bit where screws will pass.
This is not going to happen, they're going to be screwed. I use 8cm concrete screws, and I will use 5cm wooden screws on the sides.
He found something yellow, he's been barking there for 10 minutes. It doesn't show up, but I hope it's not a snake. Yellow, what you got, boy, what's there. It looks like a hedgehog. Come here, come here, yes, a hedgehog, he's turned himself off. Come on, son, don't disturb the animal, look scared, its spines go down on you, son. Come back, leave it alone, come here, no come here yellow, yellow come here, no, no, no, come here, no, no, I say. No, I'm telling you no. Come on, no.
When drilling, the drill bit is easy to drill holes and does not burn due to heat, put a little water into a glass, rust remover, oil grease, such as if you use an oil on the drill bit to prevent heating and burning holes and allows you to drill holes more easily. If you drill a guide hole with a fine drill bit first, then it will be much easier to drill with a thick drill bit. I suggest you use oil again, it is fixed by experience, your bits may burn, or you may not drill healthy holes, you drill the first one or two holes properly, but the drill bit in the next holes no longer work efficiently and you cannot drill properly. That's why it's important, you'll protect your drill bit with a little oil to put in a little water, and you'll drill more healthy and smooth holes.
Although I covered the wood, some of them became wet and they started to make mold like this from moisture. I put sandpaper on the end of the grinding machine, sanding the wood in this way, removing the mold on them. If I put a wood preservative in this way, it will rot inside out, so there's an extra job. Luckily, I didn't buy all the lumber, I got as much as I needed at first. So now I'm cleaning them up.