Alfa 147 and 156 Rear Control Arms Replacement (FAST VERSION) For full details please see: • Alfa 147 and 156 Rear ...
Пікірлер: 5
@RyderGaming3 жыл бұрын
absolute hero! My rear suspension is gonna need to be replaced on my GT (same as the 147) But I'm not gonna dish out 30 bocks for 6 bolts to do both sides.
@killawattgarage2 жыл бұрын
An easy DIY job.
@RyderGaming2 жыл бұрын
@@killawattgarage Do you happen to have any tightening torques for the bolts? I haven't got around to do it yet (because I tried to do the transverse first and that big bolt wouldn't budge). Also, should I tighten it up on the ground or is it fine if it's tightened while being lifted?
@killawattgarage2 жыл бұрын
@@RyderGaming sorry can’t remember the torque spec but tightening up on the ground is best
@RyderGaming2 жыл бұрын
@@killawattgarage I got it from an eLearn page, so for further reference for anyone: 56-72 NM for the 2 bolts in the chassis where the bush is (no need to tighten it on the ground) and 110-132 NM for the 19mm nut at the wheel. Tighten this on the ground or raise the suspension up with a jack so the two mounting points have 13mm difference in distance between them compared to the ground.