Amada HG 1003 ARs Press Brake with ATC, Bending Robot and Automated Pallet Changer at EVS Metal NJ
Рет қаралды 5,439
2 жыл бұрынFantastic to have our new Amada HG 1003 ARs press brake fully up and running at our New Jersey metal fab facility. This is our second purchase of an HG 1003 and features an automatic tool changer (ATC), bending robot, and automated pallet changer. Check out the robot in action as it forms a part all on its own!
@williamhuang5329 2 жыл бұрын
Hanzhen harmonic drive gear , strain wave reducer, robot gear joint, over 30 years experience
@ianmurphy989 Жыл бұрын
It literally took 3 minutes to run that part. I might take me about 15 minutes of drawing out and planning the bend sequence, then build the tooling. Run your first part check and unjust tooling or measurements/angles if needed, and then after that im breaking this 10 bender part in about 1 minute and a half tops. Which is half the time this thing took.
@gregn421 Жыл бұрын
You're very optimistic Ian!😉 This particular job runs quicker on the robot then manually. Let's not forget that robot runs unattended...often after we leave the shop...
@ianmurphy989 Жыл бұрын
Hopefully you can turn the speed up
@morenomax 11 ай бұрын
Is this programmed with AR cam? Or 3i
@ianmurphy989 11 ай бұрын
@@morenomax I believe ar prob cam
@MichelLinschoten 2 ай бұрын
We just sold.ours, it never worked to our satisfaction
evsmetal
Рет қаралды 2,1 М.
НОВОСТНИЧОК
Рет қаралды 16 МЛН
Olympus Technologies
Рет қаралды 1 М.
AMADA MIDDLE EAST FZCO
Рет қаралды 3,1 М.
Fifth Wave Manufacturing
Рет қаралды 23 М.
Photographer Army
Рет қаралды 2,8 МЛН
Royal Computers
Рет қаралды 742 М.