Dual Band High Gain Omnidirectional Wifi Antenna

Рет қаралды 11,321

2 жыл бұрын

You don’t seem to find any dual band high gain omnidirectional antennas for the wifi spectrum. So, in this video I show you how to make your own @5db
The ¼ wavelength used is 21.5mm with 6mm diameter tubing
Help support this channel on Patreon: www.patreon.com/user?u=20857330
Facebook group: groups/1313077415524264
Want a cantenna: tinyurl.com/4duwr3kn

Пікірлер: 26

@sunandajayakoday5418 2 жыл бұрын

This knowledge is very important to me. Thanks Mr. Andrew.

@andrewmcneil 2 жыл бұрын

Glad it was helpful!

@donplumber6141 2 жыл бұрын

Love the video how 2 but would like schematic showing your numbers and maybe turn it into a small beam antenna i have built some yagis, poles, and inverted v antennas but they were 2 meters and 70 cm frequencies

@michelfrance75 2 жыл бұрын

It is always with interest that I watch for years your instructive and very educational videos. I have a question about the possibility of using WIFI frequency to repatriate water height data in a well to a receiver at the head of this well. The well is 100m deep, circular in section and 450mm in diameter. I would like your opinion on this possibility of this process. I couldn't find a formula for wave propagation and attenuation in a long tube connected to earth. Thanks.

@hafizliaqatali472 2 жыл бұрын

Great work sir

@andrewmcneil 2 жыл бұрын

Thanks

@Manishkumar-dj6kl 2 жыл бұрын

@@andrewmcneil hello sir my question is can we increase tx power of alfa awus036nha model to gain long range signal? Default tx power of adaptor is 20dbm which work normally.

@chinesepopsongs00 2 жыл бұрын

The measurements of the coil are not clear to me, so the wire is 1,5 mm in diameter so about the same as a 2,5mm square electrical wire. But the diameter of the coil is that the inner or outer diameter??

@herdmay1 2 жыл бұрын

Great videos !! Please Share some ideas to make a feeder for parabolic antenna !!

@andrewmcneil 2 жыл бұрын

I am filming one as I type.

@freefilms10000 Жыл бұрын

is the gain of this superior to the standard aerial?

@OffGridAussiePrepper 2 жыл бұрын

??????? When are u going to build a direction antenna for 4G and LTE combined covering 700Mhz as well now that AU has stripped it from the TV bands and allocated it to mobile wireless services. Hopefully hi-gain enough for a 16km distance.

@shoukat2003 2 жыл бұрын

Antenna that u have, it is from which model of tplink? Is it dual band antenna?

@olafschermann1592 Жыл бұрын

I wish i could buy a well designed antenna like this somewhere.

@michaelporter8289 2 жыл бұрын

It's nice showing how to make the antennas but what about the mathematics behind it i.e. Lander over frequency and getting the Measurements for quarter wave half way and 3/4 wave.

@andrewmcneil 2 жыл бұрын

There are other channels that do that but unfortunately, they struggle to get the views. Most people just want to know enough to build a working antenna and are not interested in the math. If it was as simple as Lander over frequency it probably would not be too much of a problem but to truly understand it you need a firm understanding of calculus.

@arkatub 11 ай бұрын

Hi, I'm designing a computer case and want to integrate a Wifi Antenna, after trying several comercial antennas I made a Biquad based on your video and it is by far the best, 5 bars all the time, would you recommend a different design? I think I prefer directional antenna, I can make it so users can re-orient it to face their router, am i right in thinking this will perform better then any omni design?

@andrewmcneil 11 ай бұрын

A directional antenna will always out perform an omi. Fun fact though Apple tried this in 2001 but scraped the idea because people complained they had to put the pc case at weird angles and did not look cool on their desk.

@eliasroque2397 Жыл бұрын

Can be made with a coaxial tv cable?

@kevinspage 8 ай бұрын

Coaxial TV cable has an impedance of 75 ohms. Most radio systems use 50 ohm coax. For max power transfer from antenna to radio impedance should match. If you get some 50 ohm coax like used for CB radio you can trim it so the center conductor is 1/4 wave length for the frequency your looking for then fold the shield part of the coax, that is the same length as the center conductor down over the cable for the second half of the dipole. The main issue is the SMA connector which would be difficult to mate to a larger 50 ohm cable like RG58U. That's why smaller diameter coax is used in most WiFi antennas. Larger coax is better as it has less loss. You can use the wrong impedance cable but its length must match the wavelength for the frequency so whatever impedance is at the antenna end will be reflected at the radio end. Study dipole antennas for more information.

@cyberjack 2 жыл бұрын

Last time i asked what's more important width or length ? I got a slap lol

@TuttleScott 2 жыл бұрын

it's not the wavelength it's the frequency

@andrewmcneil 2 жыл бұрын

😁👍

@cyberjack 2 жыл бұрын

@@TuttleScott lol .. Good answer

@denniscleaver3559 2 жыл бұрын

Remember, in life you have three choices when it comes to the internet connection. Spend all of your life savings, by using phone data. Spend a couple of dollars monthly on nice stable wired broadband. Spend a couple of dollars only once, for a good antenna. I really like how many will actually choose the first option.

@spacemandaxx Жыл бұрын

Seems like an AI supercomputer could run billions of design iterations to come up with the most effective dual band antenna size and shape. en.wikipedia.org/wiki/Evolved_antenna