Glad it was helpful!

100W version

@@ToolsElectroDIY67 wouldn’t work?

Yes. I don’t know any more compact alternative for you at the moment

​@@ToolsElectroDIY Man you are the best thanks for the fast asnwer

Yes

No difference. You can use either port

@@ToolsElectroDIY Thank you very much 🌹

You should contact Anker for those questions. I cannot vouch for the safety of their products

Been using Anker for 7 years and haven’t had any issues with them even when I’m charging overnight.

That's the whole point of GaNPrime. Not only do they run colder than Si, they have real time temp monitoring with throttle capabilities.

Get the smaller 67W if you only need it for iPhone / iPad.

In my opinion is better the 67w because the 100w one. Is only “100”sh for one device. Then I becomes the same as the 67w

Yes pps is supported

both are fine for laptops. Just a matter of charging speed.

@@ToolsElectroDIY and about heating ? Do they hear above average ? Or they are safe in heating terms also

@@ys-50989 These and the ugreen competitor I have just get warm (I have the nexode 65w), they don't burn at all like cheaper brands such as Lintyle, those things burn like crazy. I would assume the 100w would be even better off since my Lenovo LOQ 16APH8 usb c port maxes out at 60w for charging (tested with 140w battery pack to confirm). Let's just say your laptop heats up more during normal use than these chargers do, nothing to worry about.

The 67W will get hotter and not last as long if used for your 65w labtop. There is an electronic componet there has a lifetime. And it shortens if it always runs max output. ​@ToolsElectroDIY

Thanks for sharing your experience . I don’t have ugreen

ugreen 65w chargers either whistles or make another sounds when loaded on 45w - not even at 65w (max). it's not loud, but if one's focused - they'll hear it. i've had 2 ugreen cd244 chargers and both are the same won't recommend ugreen for buying

@@penky3dyume too. UGreen is a complete trash. 😂

@@penky3dyu I have the same model, the Nexode (non pro) 65 watt and it doesn't make a sound charging either my cell at ~12-15w or my laptop and battery pack at ~60-65w. Put my ear right up to it to make sure, nada. I would return it if I was in your position and get an Anker instead, can't be trusting these sketch chargers on our laptops. A Lintyle 65 watt charger I bought before this one made electrical arc sounds every time I would plug it in and again when plugging in a usb cable. It would also heat up to the point of burning your fingers, I had to put heatsinks on it ffs.

​@@thenocturnalfoodie3176That's a HUGE exaggeration if not an outright lie. Ugreen has the 2nd best reputation after Anker. That wouldn't be the case if what you said were even close to true.

The 67W one is good enough.

​@ToolsElectroDIY how about 65w charger? Or just 67 can be a bit better?

@@pctkheem2851 67W is newer.

@ToolsElectroDIY gotcha. Even if 67w doesn't say for example 735 charger gan(ii) I'm assuming with more tech with less watts?

Is PIQ 3.0 tech good?

which one>?

Yes cable matters! See watch this review kzfaq.info/get/bejne/pZh2pdGWtb_SYYU.html

Both are fine

Yes it is safe to do so.

@@ToolsElectroDIY thanks for replying

I don’t have belkin wall charger. Yes. Yes.

Is It Safe to Use 65W Charger for Small Devices? kzfaq.info/get/bejne/ipxzgNh538Dbco0.html

@ToolsElectroDIY I guess my real question is will I cause damage to my laptop if I don't use the supplied charger and use the Anker 100watt instead? Either to the laptop battery or possibly bricking the laptop?

@@davidtaroyan no it will not cause the damage. see the video I posted in my previous comment.

I don't have the Samsung phone so I cannot verify that.

Morning!

try another AC outlet / power strip?

@@ToolsElectroDIY That's the thing. It falls off on most outlets I've tested so it's probably a design issue. How is it holding up on you end? Have you experienced any falling off issues so far?

@@thenocturnalfoodie3176 I would recommend having the outlets changed to new ones as it's just a couple of dollars and the charger will hold firm. Of course my suggestion is bias because I have only tested mine in less than 5 year old modern outlets, but I know for a fact every single outlet that was in my apartment when I moved in couldn't hold this charger, not even if it was half the weight. Those things were so old even the thin, light tv cable would droop down a bit.

Anker used to ship these longer charges with a removable rubber part that would go around the brick and help it not fall or droop, it seem to have been removed them for most bricks now.

Yes it will, if your device can take in that much wattage

@@ToolsElectroDIY tyvm I'll order it

no, the combined output won't exceed 67w

@@ToolsElectroDIY 30 + 27 +7,5 = 64,5w how that can be exceed ?

@@muhammadrizqi409 lol my bad

@@ToolsElectroDIY so how about my question ?

Because ugreen and aukey 67w only can do 45+7,5+7,5w when 3 device charging at the same time

yes

true

I didn’t know that never heard of it

This makes no sense. Either they are Si or they are GaN. It's not a continuum. Are you sure you didn't mistake them referring to the difference between GaN and GaNPrime? Only Prime has real time temp monitoring.

This doesn't make sense. It's either Si or GaN. To my knowledge, there is no Si/GaN hybrid or "partial" GaN. Are you sure you didn't misunderstand and they were referring to the difference between GaN and GaNPrime? That would make way more sense.

@@RationallySkeptical Of course I cannot find it now, but when Anker first came out with the GaN tech charger in 2018 I had to have one, and read about this on the product web page, I even emailed Anker support to ask and they verified this, but I see no reference to it now so perhaps they have overcome the limitations of the original product.

Yes, correct thanks!