ANSYS-Fluent tutorial-Dynamic Mesh for suction and compression stroke

No video

ANSYS-Fluent tutorial-Dynamic Mesh for suction and compression stroke

Рет қаралды 11,850

Күн бұрын

This video tutorial is about Dynamic mesh options available with Fluent. When your fluid domain change, it is required to modify the mesh with a fluid domain. The Dynamic mesh allows for modifying the mesh during the simulation. This tutorial considers the suction and compression event of Piston-Cylinder assembly. The smoothing and layering methods have been used. Finally, pressure contour has been captured during the suction and compression stroke.
#Engineering Nature
#Dynamic mesh

Пікірлер: 14

@vishwateja1041 Жыл бұрын

thank you for video sir but how to get dynamic mesh deformation that process you skipped in last please provide that one sir

@EngineeringNature Жыл бұрын

Thank you for your compliment. Mail us on mehulbambhania@gmail.com

@InvitationfromNature 2 жыл бұрын

Thank you sir, Explanation is too good

@EngineeringNature 2 жыл бұрын

Thanks

@umairkhawar9312 Жыл бұрын

Can you plz make a dynamic mesh video of this cylinder with valves and their timings

@MYASNIK999 2 жыл бұрын

Thank you very much for your tutorial. Are you planning to make a tutorial with dynamic 3D mesh?

@EngineeringNature 2 жыл бұрын

You are welcome. We will provide tutorial shortly.

@sportschannel7741 2 ай бұрын

how to determine cell height?

@syvongle8361 Жыл бұрын

Hi admin, thank you for your helpful video. However, when i follow your tutorial and run calculation, i meet the error: Update-Dynamic-Mesh failed. Negative cell volume detected. Can you tell me how to solve this problem?

@shashwatpatel4340 Жыл бұрын

you have not drawn the same as he has drawn in the design modeller (look at the y axis it is in the midpoint)

@lonko407 Жыл бұрын

You have to change the units to milimeter (if it doesn't work as he did, you can change it under "units..." that should help