should have outlined how bad the door was out of plumb and how much you had to keep planeing because the frame was so badly out , was very proud on this one you done a good job ✅

great to see a young lad getting stuck into the trades with a passion. keep it up and you'll go far. and having a mentor that actually cares is fantastic.

Nice to see him staying awake, hes a unit for 17 too 💪💪

You smashed it bro!

Nice effort bud, I would however invest in a smooth plane or a jack plane for fitting your doors a power plane can only do so much and can not take of fine amounts unlike a hand plane. Also when I cut veneered doors or ply doors with the track saw I initially set the saw about 2 mm deep and draw the saw backwards across the door to create a scoring cut before I then make my main cut which avoids splintering.

Best invest in one then, you don't have to buy a knew one buy a good second hand one and clean it up that's what I did when I started as an apprentice in 1989. Certainly if not a jack a smooth plane at least.

Very very good job mate awsome job. Something I do which u could try if u want or not when your drilling for the latch put a clamp on the sides of the door as it losers the risk of u coming through the side as it will become a lot harder to drill if your going in at an angle by accident that’s just something I do u may want to try it or may not keep up the good work bro

Awesome! It's not all about degrees. Trades have their role.

Ayyy, TTDOWG apprentice. Gowan lad

Great video more please 😊

Good video man 👍🏼

Did you split the door on the latch edge? You can see a split above the latch towards the end of the video.

Sick video I'm an apprentice too, are you gonna become qualified?

unreal as always

Porque Deus tanto amou o mundo que deu o seu Filho Unigênito, para que todo o que nele crer não pereça, mas tenha a vida eterna." João 3:16💕🙏🏿

7/10 was harsh!