IMPORTANT! !!!! Dont ever use Windex or Glass cleaners on any plastic. It will give it a burn and make it fog over, in just a short time. Use a monitor screen cleaner or the pre soaked towlets.

This advice will help with home consoles too. Thanks for the video

Thanks for making these videos. You guys are awesome and appreciated.

Thanks for the video - I have a House of the Dead gun right in front of me right now in pieces (too many pieces, the shell has partially shattered)

Great video. It’s not the guns that scare me. It’s those monitors

Good video. I hope you guys do more repair tips videos! It's been so long..

I've got couple of shot gun rifles that I had loaded on Sammy Deer Hunter

is it possible to get that light gun to work with a PC?

I know ita an old video but ill take any advice i can get. I jave a House of the Dead 1 with 2 Happ guns. They work fine for probably firat half of the game then start going wonky. Completely off grid. A restart of the game (power off/on) will fix it? What is wrong?

I just bought a lethal enforcer arcade and im having a slightly different issue with the guns , when you pull the trigger the screen flashes and it shows you shot a bullet but the shot doesnt register anywhere on screen , also you cannot reload , when you shoot off screen the screen flashes and doesnt reload , have you ever seen this issue before if so what could it be , also both guns were replaced by the last owner in an attempt to fix the issue , any input is greatly appreciated

Thank you! I've got a House Of The Dead machine where one gun just doesn't work and the other one only reloads

Damn, that CRT needs some work, it has horrible bloom issues. If that was my cabinet, I'd recap the entire CRT power board right off the bat.

Hi. Is there any way to make the Saturn light gun work with PC CRT monitors (has higher refresh than CRT TVs). Thank you. God bless, Proverbs 31

My guns lost... I have the game and crt TV.... How do I make one light gun?

hello,I have a two p99k logic3 gun with guncon1 and guncon2 with recoil and i need to repair one of the phototransistor, do you know where can i buy the phototransistor with 3 pins????.

Can I add a solenoid to a game that didn't originally have one?

If you were to replace the crt with a new flat screen would the light guns still work?

There is a lot of incorrect info in this. Have to question if this guy really even knows how these actually do work. Infra-red has nothing at all to do with it. No "beam" comes out of the gun. The light sensor in the gun is sensitive to light, and almost always blue light. Turning up brightness is NOT the answer and is just completely INCORRECT. Turn the brightness DOWN to get the correct black level. Then the CONTRAST UP, it is the HIGH END that the gun sees, NOT THE LOW END. Brightness adjusts the black level, not the white level. Too much brightness not only kills black levels and contrast ratios, it can often make the gun less accurate too because essentially what you are doing is making it less of a difference between full on and full off, so the gun sees light it should not really see. If you did turn up brightness on the display when using an NES Zapper it just plain won't work at all, because it relies on a black frame before the white target box. Turn the blue high level up further, that is the only colour the guns really see and care about. They don't see red at all, and they don't really care much about green. Try it for yourself and see, disconnect the blue feed into the monitor and the gun will hardly work, if at all. Yet disconnect the red and green, leave just the blue colour, and the gun will still work, probably quite perfectly. Chances are that gun would have worked fine if they actually calibrated their monitor correctly in the first place. Someone else mentioned not using Windex, and good call too, it will wreck the plastic lens. Videos like this should come with a disclaimer, these guys clearly are not qualified to be giving these tips.

@10:56 What did he say here? I can't tell with his southern drawl.